User manual AEG-ELECTROLUX ZB2941

[. . . ] Disconnect the plug from the mains before cleaning or maintenance of the vacuum cleaner. All service and repairs must be carried out by an authorised Electrolux service centre. Always keep the vacuum cleaner in a dry place. Then open the front cover on the machine and check that the dust bag, s-bag®, and the motor filter are in place. [. . . ] Turn off the vacuum cleaner by pressing the off button. A practical parking position (and at the same time a backsaving feature) when you pause during cleaning. A parking position which makes it easy to carry and store the vacuum cleaner. 10a When you want to carry the vacuum cleaner, lift the carrying handle until it clicks into place. 10b you can also carry the vacuum cleaner using the handle on the lower front edge of the machine. Xin lu y: Không s dung ban hut co gn ông c trên tham day co tua dai va ô day tham dai qua 15mm. tranh lam h tham , không nên ê ban hut ng yên môt chô khi cuôn ban chai ang xoay. Không nên ê may è lên dây in va tt may ngay sau khi s dung. Hard floors and carpets: The floor nozzle (1) motorised floor nozzle (2) recognise the surface that is being vacuumed. You can also reduce suction power for rugs. Using the motorised floor nozzle* The motorised floor nozzle is ideal for both hard floors and carpets. Carefully pull the old, dirty filter out of the filter holder and replace it with a new motor filter. reattach the filter holder containing the new motor filter. Replace the insert holding the s-bag® and then close the cover. Should be done with every 5th replacement of the dust bag, s-bag® There are two types of exhaust filter: · EF17) The filters must always be replaced with new ones and cannot be washed. * 12 Fold up the carrying handle until it clicks into place. Place your thumbs on the back edge of the lid and then open the lid by pulling the handle backwards and upwards with your index/middle finger. *A washable filter ­ HEPA H13 ­ can be bought as an option. The vacuum cleaner automatically stops if there is a blockage in the nozzle, tubes or hose or if the filter or dustbag become blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for 20-30 minutes. You can also sometimes clean the hose by "massaging" it. You should, however, be careful if there is a risk that, for example, glass or nails have become imbedded in the hose. [. . . ] Always disconnect the vacuum cleaner from the mains first. 5 In order to remove the brushroll cover, push the outer cover out, and the middle cover to the right, and this will also free the wheels for cleaning. Remove any hairs that may have got stuck by snipping them away with scissors. 4b The auxiliary wheel should be carefully pulled straight out. [. . . ]