User manual AIRLINK RAVEN MODEM

[. . . ] Raven CDMA/1xRTT User Guide AirLink Communications, Inc. Version 2. 09 December 2005 Information in this document is subject to change without notice ©Copyright AirLink Communications, Inc. , 1993-2005. All rights reserved. WARNING The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. Important Notice Because of the nature of wireless communications, transmission and reception of data can never be guaranteed. Data may be delayed, corrupted (i. e. , have errors) or be totally lost. Although significant delays or losses of data are rare when wireless devices such as the AirLink Communications modem are used in a normal manner with a well-constructed network, the AirLink modem should not be used in situations where failure to transmit or receive data could result in damage of any kind to the user or any other party, including but not limited to personal injury, death, or loss of property. [. . . ] It will be woken up when data is sent or received. No Service = There is no CDMA/1xRTT network detected. Hardware Reset = The OEM module is being reset. This is a temporary state. *NETSTATE? 59 TELUS CDMA/1xRTT Raven User Guide Version 2. 09 AT Commands TABLE 1. Information and Status Details The status of the last issued SMTP message (*SMTPSEND). If no status is available 0 is returned. The status codes are received from the SMTP server the modem attempted to send the request. 354 = send in progress, 250 = sent ok. Command *SMTPSTATUS? *SNTPQUERY?+PRL? The current SNTP (Simple Network Time Protocol) time and date. Preferred Roaming List (PRL) version. For most of the commands in the rest of the tables, you can query the current status of the associated register by substituting a "?" for any parameters, omitting the "=" if there is one, i. e. for the command *DPORT=n, you would enter AT*DPORT?. TABLE 2. Basic Commands Details AT Escape sequence Not proceeded by AT. Hang-Up Command n=1 Hang-up Writes all changed modem settings. If this command is not issued, any modified values will revert back to their previous values at modem reset. Answer - manual Disable AT Escape Sequence detection n=0 n=1 Enable +++ AT escape sequence detection. Disable +++ AT escape sequence detection. n=0 n=1 Echo Off Echo On. Command +++ The "+" is ASCII 0x2B. A/ Hn &W Parameters none none none A DAE=n none En TELUS CDMA/1xRTT Raven User Guide Version 2. 09 60 AT Commands TABLE 2. Basic Commands Details Hang-Up Command n=1 Hang-up Online (Remote) Causes the modem to go from Command State to data state. none Command Hn O Parameters Qn The AT quiet-mode setting. If quiet mode is set, there will be no responses to AT commands except for data queried. n=0 n=1 Terse (numeric) command responses Verbose command responses (Default). [. . . ] Note: A maximum of 20 index locations (0-19) are supported. Error 22 is returned if the specified index value is not in the valid range. Service Programming Code Upon successful entry of this code, all other service provisioning AT commands may be used. Generally, TELUS will provide the unlock code and type. [. . . ]