User manual AIRLIVE SNMP-24MGB

[. . . ] SNMP-24MGB 24+8 Combo Pure Gigabit SNMP Managed Switch User's Manual Copyright and Disclaimer Copyright & Disclaimer No part of this publication may be reproduced in any form or by any means, whether electronic, mechanical, photocopying, or recording without the written consent of OvisLink Corp. has made the best effort to ensure the accuracy of the information in this user's guide. However, we are not liable for the inaccuracies or errors in this guide. All information is subject to change without notice All Trademarks are properties of their respective holders. AirLive SNMP-24MGB User's Manual Table of Contents Table of Contents 1. [. . . ] Refer to the following parameters description for details. Parameter description: Port: It is the port number to be selected for configuring its associated 802. 1X 135 AirLive SNMP-24MGB User's Manual 4. Web Management in SNMP-24MGB parameters which are Port control, reAuthMax, txPeriod, Quiet Period, reAuthEnabled, reAuthPeriod, max. Request, suppTimeout, serverTimeout and Controlled direction. Mode: Range: Disable / Normal / Advanced / Clientless Disable: Disable IEEE 802. 1X for this port. Normal: All clients under this port will be authorized when one of the client do 802. 1X authentication successfully. Advanced: Each client under this port have to do 802. 1X authentication by himself. Clientless: The clients don't need to install 802. 1X client function that means the client PC (for example WINDOW XP) does not need to enable 802. 1 X client function also can do 802. 1 X authentication. But the network maintainer needs to configure the Radius server using each client's MAC address for Radius account ID and password. Port Control: This is used to set the operation mode of authorization. There are three type of operation mode supported, ForceUnauthorized, ForceAuthorized, Auto. ForceUnauthorized: The controlled port is forced to hold in the unauthorized state. ForceAuthorized: The controlled port is forced to hold in the authorized state. Auto: The controlled port is set to be in authorized state or unauthorized state depends on the result of the authentication exchange between the authentication server and the supplicant. Default: Auto reAuthMax(1-10): The number of authentication attempt that is permitted before the port becomes unauthorized. Default: 2 txPeriod(1-65535 s): A time period to transmitted EAPOL PDU between the authenticator and the supplicant. Default: 30 136 AirLive SNMP-24MGB v2 User's Manual 4. Web Management in SNMP-24MGB Quiet Period(0-65535 s): A period of time during which we will not attempt to access the supplicant. Deafult: 60 seconds reAuthEnabled: Choose whether regular authentication will take place in this port. Default: ON reAuthPeriod(1-65535 s): A non-zero number seconds between the periodic re-authentication of the supplicant. Request(1-10): The maximum of number times that the authenticator will retransmit an EAP Request to the supplicant before it times out the authentication session. Default: 2 times suppTimeout(1-65535 s): A timeout condition in the exchange between the authenticator and the supplicant. serverTimeout(1-65535 s): A timeout condition in the exchange between the authenticator and the authentication server. [. . . ] An IP address has two parts: an identifier of a particular network on the Internet and an identifier of the particular device (which can be a server or a workstation) within that network. The new IPv6 specification supports 128-bit IP address format. LACP (802. 3ad) Trunking Link Aggregation Control Protocol. It is protocol defines how to combine the several Ethernet ports into one high-bandwidth port to increase the transmission speed. Both devices must set the trunking feature to work. MAC 316 AirLive SNMP-24MGB v2 User's Manual 8. [. . . ]