User manual AIRLIVE WFP-151U

[. . . ] WFP-151U 11n Wireless Multi-function Print Server User's Manual Copyright and Disclaimer Copyright & Disclaimer No part of this publication may be reproduced in any form or by any means, whether electronic, mechanical, photocopying, or recording without the written consent of OvisLink Corp. OvisLink Corp. has made the best effort to ensure the accuracy of the information in this user's guide. However, we are not liable for the inaccuracies or errors in this guide. All information is subject to change without notice All Trademarks are properties of their respective holders. AirLive SNMP-24MGB User's Manual Table of Contents Table of Contents 1. [. . . ] PORT Name: The name of the port which MFP server plugs on. The default port name is `'p1''. 6. 4. 1. 1 Admin Password You can change the administrator's name and password from here. 57 AirLive WFP-151U User's Manual 6. Web Management in WFP-151U Name, the name of the MFP Server. You can use this name to identify the MFP Server when you are searching for the MFP Server by the "Server Manager" utilities. Password, enter the password you want to change to the MFP Server. The password can be up to 7-digit alphanumeric format. The default password is "airlive". Re-type Password, enter the same password for the MFP Server again. 6. 4. 2 Wireless Setting If you want to use the MFP Server through wireless LAN, please set up the MFP Server through Ethernet first and make sure your wireless LAN setting is correct. After setting the wireless LAN, unplug the Ethernet cable and restart the MFP Server, then you can start to use the MFP Server through wireless LAN. If the wireless configuration does not work, please plug the Ethernet cable again, restart the MFP Server and configure the MFP Server through Ethernet until the wireless LAN settings are correct. You can enable/disable the wireless function and set up the wireless parameters for the MFP Server from here. The parameters include "Function", "Mode", "ESSID" and "Channel Number". You can manually set the wireless network that you want to connect in this page or use the "Site Survey" function to automatically search for an available wireless network and associate with it. Function is for user to disable, enable or let the MFP Server auto select to connect to the 58 AirLive WFP-151U User's Manual 6. Web Management in WFP-151U wired or wireless network. If "Disable" is selected, the MFP Server can only connect to the network through wired Ethernet. If "Enable" is selected, the MFP Server can only connect to the network through Wireless LAN. If "Auto" is selected, the MFP Server can automatically decide to enable or disable the wireless function. The MFP Server only can work in either Ethernet or wireless LAN mode. It cannot work in both Ethernet and wireless LAN mode at the same time. When the MFP Server starts up, it will auto-detect if the LAN port is connected to an active network by an Ethernet cable. If the MFP Server is connected to an active network by Ethernet cable when starting up, the MFP Server will run in Ethernet mode. [. . . ] An IP address has two parts: an identifier of a particular network on the Internet and an identifier of the particular device (which can be a server or a workstation) within that network. The new IPv6 specification supports 128-bit IP address format. MAC Media Access Control. MAC address provides Layer-2 identification for network devices. Each Ethernet device has its own unique address. [. . . ]