User manual AIRLIVE WN-200USB

[. . . ] WN-200USB Wireless 11n USB Dongle User's Manual Copyright and Disclaimer Copyright & Disclaimer No part of this publication may be reproduced in any form or by any means, whether electronic, mechanical, photocopying, or recording without the written consent of OvisLink Corp. has made the best effort to ensure the accuracy of the information in this user's guide. However, we are not liable for the inaccuracies or errors in this guide. All information is subject to change without notice All Trademarks are properties of their respective holders. AirLive WN-200USB User's Manual Table of Contents Table of Contents 1. [. . . ] If you can not find the icon, please follow the procedures from step 3 to step 5. 3. Click "Start" button (should be located at the bottom-left corner of windows desktop), click "Control Panel", then click "Network and Internet Connections" in Control Panel. AirLive WN-200USB User's Manual 30 3. Click "Network Connections". 31 AirLive WN-200USB User's Manual 3. Right-click "Wireless Network Connection" (it may have a number as suffix if you have more than one wireless network card, please make sure you right-click the AirLive 802. 11n Wireless Dongle), then select "View Available Wireless Networks". 6. All wireless access points in proximity will be displayed here. If the access point you want to use is not displayed here, please try to move your computer closer to the access point, or you can click `Refresh network list' to rescan access points. Click the access point you want to use if it's shown, then click `Connect'. 7. If the access point is protected by encryption, you have to input its security key or AirLive WN-200USB User's Manual 32 3. Configuration of WN-200USB passphrase here. It must match the encryption setting on the access point. If the access point you selected does not use encryption, you'll not be prompted for security key or passphrase. 8. If you can see `Connected' message, the connection between your computer and wireless access point is successfully established. 33 AirLive WN-200USB User's Manual 4. Troubleshooting 4 Question: Answer: 4. Troubleshooting This section is intended to help you solve the most common problems on the WN-200USB. I can't find any wireless access point / wireless device in `Site Survey' function. Click "Rescan" for few more times and see if you can find any AP or wireless device. "Ad hoc" function must be enabled for the wireless device you want to establish a direct wireless link. Please adjust the position of WN-200USB (you may have to move your computer if you're using a notebook) and click "Rescan" button for few more times. If you can find the AP or wireless device you want to connect by doing this, try to move closer to the place where the AP or wireless device is located. ==================================================================== Question: Answer: Nothing happens when I click "Launch Config Utility" Please make sure that WN-200USB is inserted into your computer's USB port properly. If the AirLive configuration utility's icon is black, WN-200USB is not detected by your computer. Remove the WN-200USB and insert it into another USB port. Uninstall the driver and re-install again. Contact your local distributor for help. ==================================================================== AirLive WN-200USB User's Manual 34 4. [. . . ] A communication system of connecting PCs and other computing devices across a large local, regional, national or international geographic area. A WAN port on the network device means the port (or wireless connection) that is connected to the Internet side of the network topology. WEP Wired Equivalent Privacy. WEP is available in 40-bit (64-bit), 108-bit (128-bit) or 152-bit (Atheros proprietary) encryption modes. Wi-Fi Wireless Fidelity. An interoperability certification for wireless local area network (LAN) products based on the IEEE 802. 11 standards. [. . . ]