User manual AIWA Z-L100

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a patilcular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. [. . . ] You can adjust the recording level during analog recording and microphone recording. To record the sound source better, adjust the recording level referring to page 30. Tip record on a previously recorded disc If there is an unrecorded section left on the disc, the new recording automatically starts from where the previous recording finished. If there is not enough unrecorded section left, or you want to record after erasing previous recordings, erase the recording referring to page 62. TO protect the recorded contents + @ TO record + @ If recording or editing is attempted when the tab is set to the protect position, "F)ROTECTED appears and the operations are deactivated. 4 Press + or - referring to the level meter in the display to adjust the recording level . Set the recording level @ as high as possible but not reaching the OVER indication. Press + or - during recording in the same way as step 4. Press MODE while in recording pause mode to display "MANUAL", then press ENTER to display "A. To search for a desired passage quickly, you can register up to 254 index marks. This unit has three functions for registering the index marks. Q Synchronized digital recording may not be done from some type of Aiwa mini component. @Current track number @ Elapsed time of the current track 4 Adjust the VOLUME with MULTI JOG. When operating with the remote control, press VOL +/­. When playing the disc the next time, playback will start from that point. The power is automatically turned off after about 5 seconds. Fiic operation To pause To resume Buttonto press -II during playback >11 while in pause mode Beginning of a succeeding track Keep W or To search for a W" messed desired Doint DSL 2: Low and high frequencies are more emphasized than in DSL1. DSL 3: Low and high frequencies are more emphasized than in DSL2. To play a disc at double speed (Rapidplayback) Keep > I I pressed for 2 seconds during playback. Each time the button is pressed, the display changes in the following order. @ Current track number @Elapsed time of the current track @Title of current track (. @Remaining time of current track @ Disc name @Total number of tracks on the disc @ Recording date of thecurrenttrack (22nd October, 1998 in this case) Q "No Title" or "NO Name" appears when playing a disc in which no data is registered. [. . . ] A newly developed digital audio compression technology called the ATRAC system automatically extracts only the frequencies that are actually audible to the human ear and cuts the frequencies which are inaudible. this compresses the amount of information to be recorded to 1/5 of the normal amount. The ATRAC system is based upon studies carried out in the field of auditory psychology and does not impair the quality of the audible sound. One of the great features of the MiniDisc is that you can search for desired tracks quickly. [. . . ]