User manual AKG C747 V11

[. . . ] Please keep the Manual for future reference. Please make sure that the piece of equipment your microphone will be connected to fulfills the safety regulations in force in your country and is fitted with a ground lead. ⷠWhen scrapping the equipment, separate the case, circuit boards, and cables, and dispose of all components in accordance with local waste disposal rules. [. . . ] ) · If your mixer provides no phantom power, connect an optional AKG B 18 phantom power supply between the microphone and the mixer. You may connect the AKG B 18 phantom power supply to an unbalanced input as well. 1 Mounting All supplied mounting accessories have 3/8" inside and/or outside threads, so you can screw the H 47 mic clamp as well as the MSH 70 gooseneck on to any standard floor or table stand. ⷠTo fix any of the supplied mounting accessories to a 5/8" thread, use a commercial 3/8" to 5/8" thread adapter. Use the SA 80 to clamp the microphone on a desktop, microphone stand, flats, or other parts of a stage set up to 0. Use a screwdriver or coin to remove the connecting screw (1). Insert the SHZ 80 screw link (2) into the hole in the fin (3). Due to its reduced size and slight presence rise the C 747 V11 is an excellent choice for speech miking in conference and discussion situations as well as radio, TV and recording studios. Place the microphone about 1 foot/30 cm in front of the talker. 7: Alternatively, you can clamp the microphone to the desktop using the SA 80. You can use the SA 47 stand adapter to mount the microphone on a table stand. Place the microphone about 1 foot/30 cm in front of the talker. The saxophone radiates all of its frequencies within the 3-dB band from the bell. If you want less key click noise, move the microphone further away from the instrument and/or aim it al the outer rim of the bell. nylon and steel strung guitars are both subtle instruments. The strings, wood, lacquer, and playing style all affect the tone and it's these delicate influences that you should try to capture. [. . . ] Use a soft cloth moistened with water to clean the microphone body. SPL for 1% THD: Equivalent noise level to IEC 60268-4: Equivalent noise level to IEC 60268-4 (A-weighted): Signal/noise level re 1 Pa (A-weighted): Impedance: Recommended load impedance: Powering: Current consumption: Connector: Size: Net weight: condenser (self-polarized) hypercardioid 30 Hz to 18 kHz ±3 dB from published trace 8. To order a free copy of the Declaration of Conformity, visit http://www. [. . . ]