User manual AKG DISCREET ACOUSTICS MODULAR

[. . . ] ) gooseneck with DPA external in-line XLR phantom power adapter for permanent screw-on installation. ) gooseneck with integrated XLR phantom power adapter for temporary installation and PS 3 F-Lock panel mount socket. ) gooseneck with integrated phantom power adapter and 5-pin XLR connector, for external LED ring powering. With integrated DPA-P XLR phantom power adapter, programmable ON/OFF switch, switchable bass cut, defeatable LED ring, and PS 3 F-Lock panel mount socket. [. . . ] To prevent the circuit board from getting caught inside the barrel, make absolutely sure that the connecting wires (1) will not lie on top of the jumpers (2). You can double-check on that through the opening for the ON/OFF key as you push the circuit board home. Use the supplied PS 3 F-Lock panel mount socket to install the Installation Module in a tabletop or an optional SA 60 stand adapter to mount the Installation Module on a floor or table stand. â· For even better vibrational noise rejection, you can fix the Installation Module to the tabletop with an optional H 500 (see fig. Use a shielded cable to connect the Installation Module to a microphone input with phantom power. If the phantom power on your mixing console is switchable, switch the phantom power on. 1 LED Ring The LED rings on the GN 15/30/50 E operate off phantom power. If you connected the microphone correctly, the LED will be lit at moderate intensity as soon as you switch the system and phantom power on. This indicates that the system is correctly wired and ready to operate but NOT that the microphone channel is open. 4: DPA circuit board The DPA phantom power adapter provides a 6-dB/octave bass cut filter below 200 Hz to reduce low-frequency noise. Before grasping the circuit board, touch a bare, grounded metal part to discharge any static charge that may have built up on your body. Remove jumper J1 from the circuit board of the phantom power adapter. Pins 2 and 4 on the 5-pin XLR connector are available for powering the LED ring from an external source. The LED rings on the GN 15/30/50 Installation Modules will be powered from the phantom supply. ) To obtain an open channel indication, the installation technician may connect the LED ring to an external power source. In this mode, the LED ring will light much more brightly to draw the required attention to the open microphone. Unsolder the black wire (LED +) and the outer shield (LED -) from the DPA phantom power adapter. Thread the connecting cable of the Installation Module through the opening and the supplied fixing screw. Screw the fixing screw into the Installation Module from below to fix the Installation Module in place. â· For even better vibrational noise rejection, you can fix the Installation Module to the tabletop with an optional H 600 + A 608 shock mount (see figs. Plug the cable of the DPA phantom power adapter into the female mini XLR connector on the connecting cable of the Installation Module. Use a shielded cable to connect the DPA phantom power adapter to a microphone input with phantom power. [. . . ] Use the SA 63 stand adapter supplied with the transmitter to mount the transmitter on an (optional) ST 45 table stand. The LED ring will remain lit even if you press the MUTE button on the transmitter!Remember that the LED ring does NOT necessarily indicate that the microphone is open and will not extinguish unless you switch the transmitter OFF. Of course, you may also use the microphone handheld, e. [. . . ]