User manual AKG DMS70

[. . . ] Please read the manual before using the equipement!Do not spill any liquids on the equipment. The equipment must only be used in dry rooms. The equipment must only be opened, serviced, and repaired by authorised personnel. [. . . ] The transmitter will not function if you insert the batteries the wrong way round. Close the two battery compartment covers. switch on the transmitter with the On/Off button (15). If the status LED (13) flashes green, the batteries are in good condition but there is no radio contact with the receiver. the transmitter must be connected to the receiver. If the status LED is lit green, the batteries are in good condition and there is radio contact between the transmitter and receiver. If the status LED goes red the batteries are likely to be flat in approx. Replace with new batteries as soon as possible. If the status LED does not light up the batteries are flat or possibly incorrectly fitted. Pull the battery compartment cover down and off the transmitter. insert the supplied batteries into the battery compartment conforming to the polarity marks. The transmitter will not function if you insert the batteries the wrong way round. Slide the slide cover (20) to the rear position and switch on the transmitter using the on/off switch (15). If the status LED (13) flashes green, the batteries are in good condition but there is no radio contact with the receiver. the transmitter must be connected to the receiver. If the status LED is lit green, the batteries are in good condition and there is radio contact between the transmitter and receiver. If the status LED goes red the batteries are likely to be flat in approx. Replace with new batteries as soon as possible. If the status LED does not light up the batteries are flat or possibly incorrectly fitted. Push the slide cover over the on/off switch to prevent the transmitter from being switched on/off inadvertently. To close the battery compartment, slide the battery compartment cover onto the battery compartment from below until the snap hook engages. When delivered, the transmitters are preconfigured to channels 1 and 2 of the receiver. [. . . ] The connected transmitters switch off automatically after two minutes without radio contact with the receiver. The receiver is switched off, there is a power failure, the transmitter is out of range, or a new transmitter is not registered. No sound because dual channel usage is not permitted. Status LED (13) of the transmitter flashes green, because another transmitter is active on the same channel on the receiver. [. . . ]