User manual AKG HSD 171

[. . . ] The microphone arm features a microphone muting function and swivels through a 270-degree arc so you can wear the headset with the microphone on your left or right. The 10-foot (3-m) connecting cable has a coiled section and interfaces with the headset through a 6-pin mini XLR connector. This connection allows you to replace the cable quickly and easily. All models are suited for any radio or TV application requiring optimum speech reproduction. [. . . ] the on/off switch is actuated by the headband. If you hang the headset up by the headband, the headphones may switch ON. 1 Windscreens W 44 (HSC 171/271), W HSD (HSD 171/271/271 Single) If you use the headset in the open or need to place the microphone extremely close to your mouth, we recommend using the supplied foam windscreen. Pull the ear pad(s) off the earphone(s). To attach the new ear pad(s), pull the elastic hem of each ear pad over the rim of the earphone base plate all around. Pull the connecting cable off the headset. Note: When you connect the cable again, the connector will lock automatically. To prevent the microphone from picking up unwanted signals or causing feedback (models HSC 171 and HSD 171 provide no headphone muting function), be sure to move the microphone arm into its vertical center position every time before taking the headset off. this keeps the microphone signal muted even if the microphone channel remains open. The HSC-PA phantom power adapter features a bass cut filter to suppress low-frequency noise and reduce proximity effect. The headsets are delivered with the bass cut filter deactivated. Disconnect the phantom power adapter from the mixer input. Remove the fixing screw (1) from the phantom power adapter. Pull the pcb out of the shell WITH EXTRA CARE. Remove the jumper (3) from the contact pins (4) to activate the bass cut filter. In order not to lose the jumper (3), place it on any two contact pins (4) in a position at right angles to the ON position. To deactivate the bass cut filter, place the jumper (3) on any two contact pins (4) as per Table 5 below. Bass cut filter ON Bass cut filter OFF Push the pcb into the shell, replace and tighten the fixing screw (1), and screw the cable bushing (2) onto the blue strain relief (5). Disconnect the phantom power adapter from the mixer input. Remove the fixing screw (1) from the phantom power adapter. [. . . ] (3 m) long; coiled section; with 6-pin female mini XLR connector, 1/4" TRS jack plug (headphones), and 3-pin XLR connector (microphone) matte black 255 g (9 oz. (3 m) long; coiled section; with 6-pin female mini XLR connector, 1/4" TRS jack plug (headphones), and 3-pin XLR connector (microphone) matte black HSD 271: 305 g (10. To order a free copy of the Declaration of Conformity, visit http://www. Spare parts are available from AKG Acoustics GmbH, Serviceabteilung, Lemböckgasse 21-25, A-1230 Wien, Austria. [. . . ]