User manual AKG PT 4000

[. . . ] We recommend replacing the battery with a new one as soon as possible. If you use a rechargeable battery, the LED will change to red 15 minutes before the battery will be dead!3 Audio input: 3-pin mini XLR connector with both mic and line level pins that automatically match the connector pinout of the recommended AKG microphones or optional MKG L guitar cable. 7 Viewing window: The viewing window lets you check if there is a dry or rechargeable battery inside the battery compartment. [. . . ] We recommend replacing the battery with a new one as soon as possible. If you use a rechargeable battery, the LED will change to red 15 minutes before the battery will be dead!3 Audio input: 3-pin mini XLR connector with both mic and line level pins that automatically match the connector pinout of the recommended AKG microphones or MKG L guitar cable. 4 Frequency selector: This slide switch tunes the transmitter to one of three different carrier frequencies within the transmitter's carrier frequency band. 8 Viewing window: The viewing window lets you check if there is a dry or rechargeable battery inside the battery compartment. You can also place a white lettering strip (supplied) or a color code strip (optional) behind the viewing window. 9 GAIN: This rotary control inside the battery compartment allows you to match the bodypack transmitter input gain to the microphone or instrument you connected to the transmitter. 10 Carrier frequency label: The label on the transmitter rear panel indicates the name of the carrier frequency band and the three carrier frequencies of your transmitter. refer to the Manual Supplement sheet for a color code table. The PT 40 PRO and PT 4000 bodypack transmitters have been designed for use with the following AKG microphones: · C 519 ML If you wish to connect other microphones from AKG or other manufacturers to your bodypack, please note that you may have to rewire the existing connector on your microphone or replace it with a 3-pin mini XLR connector. The MKG L guitar cable from AKG lets you connect an electric guitar, electric bass, or remote keyboard to the bodypack transmitter. ), the lower the sensitivity of the receiver and thus the usable range between transmitter and receiver. In each frequency band, the spacing between the three carrier frequencies of all WMS 40 FLEXX transmitters and receivers is wide enough for operating three radio channels simultaneously with no mutual interference. For systems with up to nine channels you will need WMS 40 FLEXX kits in up to three different frequency bands. Please ask your dealer which frequency bands are suited for multichannel use and approved for the place where you will use the system. Perform steps 1 through 6 for each frequency band separately. Repeat steps 1 through 5 for channels 2 and 3. Never operate two or more wireless channels on the same frequency at the same time and location. This would cause unwanted noise due to radio interference. To activate the new carrier frequency, switch the transmitter back on. Clamp the microphone on your clothing as close as possible to the talker's mouth. ⷠRemember that gain-before-feedback will be the higher the closer the microphone sits to the user's mouth! [. . . ] This barrier prevents the microphone sound entries from being clogged by perspiration or makeup, which would make the sound dull and reduce the sensitivity of the microphone. Therefore, never remove the moisture shield from the microphone!Use a soft cloth moistened with water to clean the surfaces of the PT40 PRO and PT 4000 transmitters. Transmitter is too far away from re- 10. [. . . ]