User manual AL-KO KHS5200

[. . . ] Safety shoes, protective gloves and eye protection should be worn. A risk of injury exists emanating from timber splinters. Clothing should be practical (close fitting) and should not hinder the wearer. A hair net must be worn to retain long hair. [. . . ] A/B) Protection cover Log pusher Log guide tubes Splitting wedge Piston rod Transportation bracket ON/OFF switch on electric motor Operating lever Rear feet (only KHS 5200) Support foot (only KHS 5200) Park position transport wheels (only KHS 5200) 12 Front feet (only KHS 5200) 13 Front cross member (only KHS 5200) 1 2 3 4 5 6 7 8 9 10 11 GB 2 GB Unpacking/Assembly Caution!The log splitter should only be used when all its component parts have been completely assembled. Inform the dealer if deficiencies are detected. Note: Tools required for assembly/operation are depicted in Illus. These are not included in the scope of delivery. The log splitter should not be operated if components (e. The protective hoops) are missing or defective or the connection cable is damaged. The log splitter should not be operated if components are missing, defective or loose. With cracks, cuts, crushing damage or bends in the insulation) should not be used. Visually inspect the hydraulic components for leaks. 1-2) from outside through the wheel and through the tube (Illus. The log splitter should only be used by one person. Position the log splitter horizontally on a level, firm surface, better with a slight inclination towards the operating lever (since the valves are seated here). if inclined towards the splitting wedge it loses splitting force. Do not deposit the log splitter on the connection cable!Lay the connection cable so that it cannot be damaged by bending, crushing or otherwise. The transportation wheels with model KHS 5200 are only used to transport the log splitter. During splitting operation, the wheels must be removed from the feet and mounted in the park position. Note: After splitting, tighten the venting screw (Illus. Depending on the length, lay the log such that the wooden log is held by the log guide tubes. Never lay the log on the splitter in transverse direction, see Illus. Never force the splitting of a log by sustaining the hydraulic pressure over several seconds. [. . . ] Malfunction Cause Remedy Top up hydraulic oil The log pusher does not move Too little hydraulic oil out/in Hydraulic pump is defective Replace hydraulic pump The splitter is inclined towards the splitting Position the splitter on a horizontal plane or wedge inclined towards the operating lever The log pusher does not exert Too little hydraulic oil any force Top up hydraulic oil The splitter is inclined towards the splitting Position the splitter on a horizontal plane or wedge inclined towards the operating lever Hydraulic pump makes a Too little hydraulic oil Top up hydraulic oil whistling noise, the log pusher moves with a jerking motion The splitter is inclined towards the splitting Position the splitter on a horizontal plane or wedge inclined towards the operating lever Air inside the circulation system Motor becomes excessively hot Motor is not starting Cable cross section is too small Thermostatic switch has switched off Mains plug or socket is defective Cable is defective Electric motor is defective Open the venting screw Use cable with larger cross section Wait until the motor has cooled down Let an electrician check the plug Replace by an electrician Let an electrician check the motor Environmental protection, disposal Do not dispose of old units in household waste!The packaging, unit and accessories are made of materials that can be recycled and should be disposed of in a suitable manner. Priključno napeljavo položite tako, da ne more biti preganjena, zmečkana ali se na drug način poškodovati. Hold arbejdsområdet frit for træstykker og andre genstande – fare for at snuble. [. . . ]