User manual ALCATEL-LUCENT OMNIACCESS 512 GETTING STARTED GUIDE

[. . . ] OmniAccessTM 512 Getting Started Guide May, 2002 Safety Information: OmniAccessTM 512 hardware installation and maintenance is to be provided by Customer Support personnel, or equivalent, knowledgeable in basic electrical and mechanical safety procedures. Safety Information for Rack Mounting: Switches should be installed in a maximum 40° C environment. To ensure proper air flow, it is recommended that the switches have at least two inches of clear space on all sides. To ensure stability, precautions should be taken to prevent uneven loading of the rack. [. . . ] About Partition Management Partition Management allows you to restrict access to particular switch features on a per user basis. See the "Switch Security" chapter in your OmniAccess User Manual for details. The following procedure uses the admin login account as an example. Complete the following steps to log in to the switch. o Note o If the switch will be managed via SNMP, refer to your switch's user manual for instructions on setting SNMP passwords. To return to CLI mode from UI mode, type either cli or exit at the UI prompt (/=>) and press <Enter>. 4. Set up a Password Before you begin configuring your switch, you should change the password for the admin login account. The admin login account provides full access to all switch management functions. The factory default password for the admin account is switch. Use the following procedure to change the password for the admin account: Setting Up Software 7 o Caution o Your password is stored (encrypted) in the mpm. cnf configuration file. If you remove this file and reboot the switch, your login password (as well as all user-configured data) will automatically reset to the factory default. In this event, you must start over from Step a (see preceding page) to change the password. c. To view the system date, enter system date at the CLI prompt and press <Enter>. The system date will be displayed, as shown here: -> system date 06/11/02 d. To change the system date, enter system date mm/dd/yyyy at the CLI prompt and press <Enter>. The system date will be displayed, as shown here: -> system date 06/12/2002 5. Set the System Time and System Date Complete the following steps to set the system time and system date: a. To view the system time, type system time at the CLI prompt and press <Enter>. The system time will be displayed, as shown in the example below: -> system time 10:53:19 6. Enter a System Description (Optional) You can use the following CLI commands to view or specify a contact person for the switch, a switch name, its location, a description of the switch, and the switch's MAC aging timer value. Although this information is not required, you may find it helpful for managing the switch. To view the department or network administrator for the switch, type system admin-contact at the CLI prompt and press <Enter>. If no network administrator has been specified, Unset will be displayed, as shown in the example below: -> system admin-contact Unset b. [. . . ] Please refer to the OmniAccess 512 User Manual for information on the DC version (OA512-DC) of the OA-512. Power Switch. To turn the switch on, move the power switch to the on (I) position. To turn the switch off, move the switch to the off (O) position. 14 OmniAccess Basics OA-512 Management and Port LEDs OK1 (Hardware Status). If the internal switch Green when the switch has successfully passed power-on hardware diagnostics. [. . . ]