User manual ALCATEL BABY LINK 290 // ENGLISH

[. . . ] line jack CAUTION: Use only the power adapter (6Vac 300mA) that came with this unit. Using other power adapters may damage the unit. Contact your local distributor if you need to order replacement for the power adapter. Telephone base and handset layout Settings Ringer Volume You can select the handset ringer volume from four levels or turn the ringer off. Press UP to increase or DOWN to decrease the ringer volume when the handset is in idle mode. [. . . ] 2. Press MUTE again to resume conversation. Temporary tone dialing If you are using pulse (rotary) dialing service, you can temporarily switch from pulse to touch-tone dialing during a call. Press */TONE during a call to activate this feature. The telephone automatically returns to pulse dialing after you end the call. Troubleshooting guide If your telephone system is not operating properly, first try these general reset procedures: 1. nplug the power adapter from power outlet. U 2. isconnect the telephone line cord from the base or modular D jack. 3. emove the battery compartment covers and unplug all handset R batteries. 4. e-install all handset batteries after a few minutes. R 5. lug the power adapter back into the power outlet. Be sure not P to use outlets that are controlled by wall switches or timers. 6. lace the handset in the telephone base to charge without P interruption for at least 30 minutes before use. 7. lug the line cord into the telephone base or modular jack and P verify operation. eplace batteries that appear to be swollen or have damaged R wiring. o not dispose of the battery(ies) in fire. Check with local codes for possible special disposal instructions. o not open or mutilate the battery(ies). Released electrolyte D is corrosive and may cause damage to the eyes or skin. xercise care in handling battery(ies) in order not to short E out the battery(ies) with conducting materials such as rings, bracelets, and keys. The battery(ies) or conductor may overheat and cause burns. o not attempt to recharge the battery(ies) provided with or D identified for use with this product that are not rechargeable. The battery(ies) may leak corrosive electrolyte or explode. o not attempt to rejuvenate the battery(ies) provided with or D identified for use with this product by heating them. Sudden release of the battery(ies) electrolyte may occur causing burns or irritation to eyes or skin. [. . . ] 13. Discard “dead” battery(ies) as soon as possible since “dead” batteries are more likely to leak in a product. 14. Do not store this product, or the battery(ies) provided with or identified for use with this product, in high-temperature areas. Batteries that are stored in a freezer or refrigerator for the purpose of extending shelf life should be protected from condensation during storage and defrosting. Batteries should be stabilized at room temperature prior to use after cold storage. [. . . ]