User manual ALCATEL XS

[. . . ] To answer the call, press the key to answer the call. Make a call Once the memories are configured, you can make a direct call to the preset memory. (How to preset memory refers to table 1) - Press and hold key for 3 seconds to dial memory M3 Or - Press and hold key for 3 seconds to dial memory M1 Or - Press and hold key for 3 seconds to dial memory M2 - The Alcatel XS will take the line automatically and dialed the associated number. Remark: If no number has been preset, 2 beep tones are emitted indicating the memory is empty. [. . . ] Phone settings Your XS comes with a selection of settings that you can change to personalize your Alcatel XS the way you like it to work. Base Charger Use your mobile phone to dial in the telephone number that Alcatel XS is connected to, then answer the call with the Alcatel XS by pressing key to enter communication mode. Then, your mobile phone are in communication with the Alcatel XS and ready for programming. To do setting, always start with and terminate with # using your mobile phone keypad. When entering the key using your mobile phone keypad, the LED of Alcatel XS will remain on blue, i. e. It is advised to set your mobile phone in mute mode for avoiding any acoustic interference with Alcatel XS handset during setting of your Alcatel XS. Example for programming the Memory M1 or M2 or M3: DC plug from AC adaptor 2. 2 Installing and charging the batteries 1) Slide down to open the battery compartment cover. 2) Place the 2 supplied AAAA rechargeable batteries as indicated. Pay extra attention to direction of polarity. 3) Slide the battery compartment cover back. 4) Put the handset on the base and charge for 24 hours before using the handset for the first time. The handset will give a beep when it is properly placed on the charger. The LED is lighted up in Red and the handset will give a beep. Remove the film before use When the communication mode is set up, press key on the keypad of your mobile phone. Press 2 digits (0 and 1) for programming the Memory 1 or digit (0 and 2) for the memory 2 or digit (0 and 3) for the memory 3. Then enter the number from the keypad of your mobile phone to edit the memory number. Terminates by key #, a long beep confirmation tone is emitted to confirm the programming. In case of mistake in the entry, you can always terminate the ongoing command by entering key # and resume with key without releasing the communication mode. In case of error in the command a double beep error tone is emitted after entering key #. In that case, resume the command by entering key . Notes: 1) Use only the supplied NiMH rechargeable batteries. 2) If the handset will not be used for a long time, disconnect and remove the batteries to prevent possible leakage. During the preset of the Ringer volume and Melody, the Melody is played back after entering the digit 1 to 5. The digit selection must be entered when the melody is ended. WARNING: Always press complete your settings. key again to disconnect Alcatel XS from the communication mode after you TABLE 1: PROGRAMMING SETTING Menu name Ringer volume control Ringtones on handset Quick dial Quick dial Quick dial Default settings Registration to be described in Section 4. 1 Pin Code Number Action Ring volume control Choose ringer melody Program M1 Program M2 Program M3 Secuencia en el teclado alfanumérico press " 05" + " "value" +"#" (complete by hearing a confirmation tone); value = 0 to 5 Wait the end of the melody for selecting another volume. [. . . ] The line is busy, as another handset is used. XS is not yet registered with the base. Solutions a. Check that the telephone line cord has been plugged into the base station and the phone socket. Check the base station plug and the 230V plug (remove and plug-in). [. . . ]