User manual ALESIS EURO QCARD

[. . . ] When not in use for long periods of time, remove the batteries to prevent them from leaking. If they leak, wipe away the liquid from inside the battery compartment. Do not heat, disassemble, or dispose of batteries by throwing them into a fire. CH 1/2 INPUTS ­ Connect your external sound sources to these inputs. [. . . ] all other times , the inputs will be heard. WARNING: Turn the HEADPHONE VOLUME all the way down before turning on the unit to prevent the power-on "click" noise in your headphones. 12 10 9 MICROPHONES ­ Record your source with these built-in condenser microphones if you are not using the CH 1/2 INPUTS. SLED ­ This plastic cover slides and snaps onto the recorder to protect and secure the iPod while it is docked. Top Back DOCK ­ Connect your iPod here before attaching the SLED. While recording, these meters measure the input levels of the CH 1/2 INPUTS or built-in MICROPHONES. (If the LIMITER is on, these readings are taken after the LIMITER has processed the signal. ) During playback , these meters measure the iPod playback level. Also, the top two red LEDs will flash simultaneously when the batteries are getting low. The top two red LEDs will flash simultaneously when the batteries are getting low. STAND MOUNT ­ You can use this hole to mount the iPod Recorder on a stand, such as a standard camera stand, allowing for hands-free recording. use the thicker pad for a regularsized iPod (Classic or 5th Generation) or the thinner one for an iPod nano (2nd or rd 3 Generation). Place the foam pad on the center of the flat surface above the DOCK. This will help secure your iPod while it is docked. Connect your iPod to the DOCK by gently inserting the DOCK's connector into the slot at the base of your iPod. slide the SLED over the recorder so it covers the iPod. The edges of the SLED should slide under the tabs on both edges of the recorder. Note: We have included two different sleds for use with the iPod Recorder: one fits the regular iPod while the other fits the iPod Nano. snap the SLED into place at the bottom. To remove the SLED, pull the OPEN switch on the left panel towards the bottom of the recorder (see SIDE PANEL FEATURES), then slide it off the recorder. To remove your iPod, gently rock it back and forth until it is loose from the DOCK. The iPod Recorder is compatible with the following iPod models: iPod Classic 5th Generation iPod 3rd Generation iPod Nano 2nd Generation iPod Nano You can record to the iPod Recorder using the built-in condenser microphones, external microphones, or other audio sources connected to the recorder's CH 1/2 INPUTS. [. . . ] We recommend leaving the iPOD CHARGE feature off while recording. Charging may introduce low-level noise into your recordings. If you are using mono input sources, such as guitars and microphones, you may wish to record in mono. If you are only using one input, you should decrease the CHANNEL GAIN of the unused input to reduce unwanted noise. [. . . ]