User manual ALESIS JP QCARD

[. . . ] Switch everything on in the following order: · Computer When turning off, always reverse this operation by: · 0 be turned off before connecting and disconnecting any sources to the inputs of the unit. However, do not turn off the MultiMix USB 2. AUX B: Controls level routed to internal effects processor or ­ if a device is patched into the Aux B returns ­ routes channel signal to an external device like an effects processor. [. . . ] AUX B: Controls level routed to internal effects processor or ­ if a device is patched into the Aux B returns ­ routes channel signal to an external device like an effects processor. 0, the MONO channels' pan position is ignored when recording the individual channel but is captured when recording the MAIN MIX channels. AUX RETURN A: Controls the signal level that returns from AUX A. EFFECTS/AUX RET B: Controls the signal level of the internal effects or the level returning from AUX B if in use. USB/2TK TO MIX: Routes the stereo return from the computer as well as the 2TK input to the MAIN faders. USB/2TK TO CTRL ROOM: Routes the stereo return from the computer as well as the 2TK input to the HDPH /CTRL RM output. 0 allows you to record every individual channel to the computer, along with the main mix. The recorded signal is post-Gain, post-EQ and post-fader, which means that the settings you make to these controls will affect the recorded signal. 0's signals into and out of your computer applications properly. 0 Connect your output devices - headphones or speakers, or both - to the MultiMix USB 2. Turn their volume down to zero Turn on the MultiMix USB 2. 0 and your computer Turn your computer on NOTE: If your computer "hangs" when following this procedure, turn off both the mixer and the computer. 0 only after your computer has completely booted up. 0 to achieve a strong signal which does not distort (clip) Use the equalizer to sculpt the sound To record the signal along with the built-in effects or AUX bus effects, record the master fader signal. individual channel signals include EQ but do not include effects On the MultiMix USB 2. 0, assign the "2-TK" output from the computer to the monitor mix Raise the monitoring level (headphones or monitor speakers) on the MultiMix USB 2. [. . . ] 0 to achieve a strong signal which does not distort (clip) Use the equalizer to sculpt the sound To record the signal along with the built-in effects or AUX bus effects, record the master fader signal. individual channel signals include EQ but do not include effects On the MultiMix USB 2. 0, assign the "2-TK" output from the computer to the monitor mix Raise the monitoring level (headphones or monitor speakers) on the MultiMix USB 2. [. . . ]