User manual ALINCO DJ-196

[. . . ] Usage of Config file 5. 1 Export to Cfg file 5. 2 Import from Cfg file 6. FAQ ALINCO Flymentor 3D User Manual Foreward Thank you for choosing ALINCO Flymentor 3D, it is a high performance intelligent device. The Flymentor 3D is suitable for beginner, it will enable you to hover the helicopter, and makes practicing much easier and less stressful. To gain the best effect, you should configure your Flymentor according to your own condition, because the working of Flymentor relates to mechanism of helicopter. [. . . ] Please do it as following steps: 1 Ensure Flymentor 3D is mounted, and all electronic devices have been connected successfully. 2Turn on transmitter, ensure throttle stick on lowest position. 3Place helicopter on a horizontal surface, power up. 4Wait for Flymentor 3D initialization finished. 5 Lean helicopter to one side, watch the reaction of swash plate. If servo reverse setting is correct, the Flymentor 3D will control swashplate to the opposite side. That means when helicopter lean to left, the swashplate should lean to right (relative to main axis), when helicopter lean to front, the swashplate should lean to rear, etc. See diagram 3. 4. 2. Reaktion Lean helicopter to left side Swash lean to right Diagram 3. 4. 2 Correct Flymentor 3D reaction 6If the reaction is wrong, connect Flyementor with computer, change reverse setting and save it. ( You can keep connection when Lean-testing) 7Repeat step 4, 5 until reactions of all directions are correct. * Attention: to avoid injury, please unmount main rotor and shut off power!17 ALINCO Flymentor 3D User Manual 3. 4. 2 Servo neutral Servo neutral should be set after reverse is set. You should adjust neutral to make the rocker at suitable position. 6) If the range is not suitable, connect Flymentor 3D with computer, change reverse setting and save it. Tail delay The parameter is used to fit feature of tail servo. The response speed of tail servo is slower, the parameter should be set larger. If some high quality servos are used, you should set a little value, such as 0. Head holding angle range The parameter controls the inertia of turning. The inertia means the extra rotation when you make a direction turning. When you begin moving the rudder stick, it will cause a rotation (head direction changing of the helicopter), when you stop moving the rudder stick, the helicopter will not stop rotation immediately because of the inertia, it will rotate an extra angle before stopping. The parameter controls the angle. 3 4. 2 Adjusting 'Advanced parameters' The page controls working mode of Flymentor 3D. It is strongly recommended to keep them as factory setting when you do not know them well. 23 ALINCO Flymentor 3D User Manual Diagram 4. 2. 1 Advance page 4. 2. 1 Working mode The Flymentor 3D has two working modes: balancing mode and positioning mode. See section 4. 2. 2 for details of mode switching. [. . . ] 29 ALINCO Flymentor 3D User Manual When this happens, it is recommended that you use this function to restore Flymentor 3D to factory settings. Then do some changes on the base of factory settings. Click 'Reset' button, settings on screen will restore to factory default value, then click 'Write' button, settings will be saved into Flymentor 3D after progress bar shows finished. 'Reset' button Modify flag 'Write' button Diagram 6. 1 Reset to factory settings * Attention: if ' Write' function did not be executed, the factory setting would not be save into Flymentor 3 D. 7. FAQ Q: Serv os have no action A: Refer to section 1. 4, make sure the Flymentor 3D is working properly. [. . . ]