User manual ALINCO DJ-X1

[. . . ] This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. [. . . ] In addition, connecting the DJ-X7 to your computer enables you to change the factory defaults and separate each bank of the normal memory channel as you desire. (Up to 50 banks x Desired number of channels should equal to less than 1000 channels. For instance, maximum 20 channels can be stored in each of the 50 banks. ) This function enhancement is available only by the editing software, and can't be operated with the keypad of the receiver. MW 2. Press the V/P/M key to switch to the Memory mode. 3. Select a channel you wish to delete by rotating the dial. PRI MW 4. Press the [F] key, and press the icon ON. V/P/M key with the 4 Basic Operations A beep sounds telling that the channel and its frequency are deleted successfully. Then, "------" is displayed on the LCD. 5. With "------" displayed on the LCD, return to the Memory mode by rotating the dial. Otherwise, PRI MW press the V/P/M key to return to the VFO mode. PRI When there are no more channels programmed to the MW memory, press the V/P/M key to return to the VFO mode. Right after deleting a channel with "------" displayed on the LCD, you can restore what you erased. To undo the deletion, press the [F] key and press PRI MW the V/P/M key with the icon ON. Note that you won't be able to restore it once you change the operating mode. 21 Chapter 5 Advanced Operations 5. 1 Scanning Function This function automatically searches for active frequencies to help you locate the signal that you wish to receive. Press the key to switch to the VFO mode, if 3. Press the TONE BAND key to select an AM, FM, or TV station. Press the necessary. V/P/M TONE SCAN 2. While holding the SCAN key down, rotate the dial to select a pair of programmed scan channel you wish to search through. Either A or b of the pair will scan the same range. TONE This starts the preset scan. The decimal point (. ) on the LCD blinks during the operation. When the DJ-X7 detects a signal, the scanning operation will be suspended. 5 Advanced Operations Memory scan In the Memory mode, signals are detected from the specified bank or all the banks. There are three types of scanning methods in this memory scan. Bank scan. . . . . . . . . . . . . . . . . . . This scans only through a specified bank. Linked banks scan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . This scans multiple banks which were linked beforehand. Release the SCAN key. When you selected "A" side, the scanning performs in the direction of "b" side. Conversely, when you selected "b" side, the scanning performs in the direction of "A" side. 4. [. . . ] Otherwise " " is displayed on the Master's LCD, and the Master suspends transferring. · Note that all data stored on the Slave are overwritten with the Master's if cloning is executed. Be sure if it's OK before cloning. 35 7. 3 Operation for Transferring Data (on the Master) 1. Hold the PWR key for 1 second to turn the power ON while holding the [MONI] key. The following is displayed on the LCD, and the Master enters the Clone mode. 2. [. . . ]