User manual ALPATEC AC 9 E

[. . . ] cAUTION When using electrical appliances, some rules have to be respected. Take care to install this product by complying with the national rules of electric installation. Make sure that the voltage on the rating plate is same as your main one before plugging. ⷠPlace the appliance on a dry and level surface, with enough room, without obstacle. [. . . ] ⷠDo not put anything on the appliance. it has to be repaired by a qualified worker. Power cord has to be changed by a qualified person if needed. STARTING: Plug in the unit, a sound « bip » is heard. Press button M/A (I), the unit starts setting the last used parameters (mode, temperature and fan speed). Each time, function changes according to following diagram: COOLING -> DRY -> FAN ONLY -> COOLING. A few seconds after, surrounding temperature will be displayed again. Each pressure, fan speed changes according to following diagram: LOW -> MEDIUM -> HIGH DRY MODE. During the dry operation, the fan speed cannot be adjusted. A sound can be heard and the unit stops running. TIMER: To turn on the unit automatically, press TEMPS (K) touch when unit is plugged but not running. Set remaining time before starting using + / - (M) touches. Each pressure adds or removes half an hour, from 0. To turn off the unit automatically, press TEMPS (K) touch when unit is plugged and running. Set remaining time before stopping using + / - (M) touches. Each pressure adds or removes half an hour, from 0. Remaining time before stopping is displayed on LED screen (E) and after a few second, room temperature is displayed again. Flow can be adjusted in both A and B directions. If you do not use the air conditioner, you can close the hole using the cover of part 12. - Through the window or the door: Assemble window accessory 10 on exhaust pipe extremity. [. . . ] Before asking for repair service, please check: Problems Unit does not work Causes It is not plugged in Socket or plug is damaged fuse or power cord are damaged Suggest solution Plug in Change it Make it repair by a qualified person Unit stops working automatically Room temperature is lower than set temperature Evaporator is frosted Voltage is too high or too low Unit is damaged When there is something wrong with your unit, contact a qualified person. Rotative compressor Max cooling capacity Cooling capacity Input power Dehumidifying capacity Air flow (min ­ max) Fan speed Exhaust pipe length Exhaust pipe diameter Suitable for rooms up to R 407 C 2360 W 2022 W 777 W 48 L / day 270 m3 / h 3 1. Instructions on environment protection Do not dispose of this product in the usual household garbage at the end of its life cycle ; hand it over a collection point for the recycling of electrical and electronic appliances. The symbol on the product, the instructions for use or the packing will inform about the methods of disposal. [. . . ]