User manual ALPATEC PI 242 EHUV

[. . . ] cAUTION Before using electrical appliances, you must respect some precautions. Make sure that the voltage rating on the type plate corresponds to your main voltage. ⷠKeep out of children and do not allow them to operate this appliance. [. . . ] Direct UV light exposure to the eyes can cause temporary or chronic effect on your eyes. ⷠOnly use the appliance for domestic purposes and in the way indicated in these instructions. Never use accessories that are not recommended or supplied by the manufacturer. It could constitute a danger to the user and risk to damage the appliance. ⷠAll interventions made by a non-qualified person can be dangerous; in this case guarantee conditions would cancel. - The appliance eliminates particles such as pollen, dust, acarians, micro-organisms, noxious gases, smokes and it neutralizes any germ alive such as virus and bacteria. - 4 adjustable speeds : select high speed to quickly purify the room air then select low speed half an hour later to preserve pure and fresh air. 1- Base 2- Front cover (air outlet) 3- Control panel 4- Handle 5- Rear cover (air inlet) 6- Rear cover fixing 7- Pre filter 8- HEPA filter : removes particles as small as 0, 3 microns 9- Activated carbon filter : reduces odours 6 5 D 7/8/9 CONTROL PANEL : A ­ On/off touch B ­ Speed selection touch C ­ Ion touch D ­ UV touch E ­ Timer touch F ­ LED display 1- Install the appliance at least 2 meters away from TV set, radio . 2- Do not blow air directly into the air purifier. 3- Keep the appliance at least 10 cm from the wall. - Press M/A touch (A), the appliance starts in the latest UV speed selected. Indicator - Press speed touch (B) to select the fan speed : SILENT LOW MEDIUM HIGH - When the appliance is running, press timer touch (E) to select the time. One pressure corresponding to one hour : 1h --> 2h --> 3h --> 4h -->5h --> 6h --> 7h --> 8h --> 9h --> 10h -->11h --> 12h --> no time The selected time appears on the LED display. - Press UV touch (D) to activate the UV light and neutralizes bacteria. - When the filter indicator replacement is light on, the HEPA filter must be replaced. After replacement, insert a small object (such as a pin) into the hole marked RESET while the unit is on. You will hear 3 beeps, the unit is ready for a new filtering cycle. Note : if the air quality is very poor you may replace the hepa filter before the hepa indicator is light on. [. . . ] Hepa indicator is light on after replacement of filters. Instructions on environment protection Do not dispose of this product in the usual household garbage at the end of its life cycle ; hand it over a collection point for the recycling of electrical and electronic appliances. The symbol on the product, the instructions for use or the packing will inform about the methods of disposal. [. . . ]