User manual ALPINE CHA-S614

[. . . ] Then have the necessary parts ready before you begin installation. NOTE: For the vertical installation be sure to install the Shuttle with the CD magazine slot facing upward. IMPORTANT Please record the serial number of your unit in the space provided here and keep it as a permanent record. Installation of Shuttle With the CHA-S614, CDs are automatically removed from and reinserted into the CD magazine, DO NOT mount the unit upside down, as this could cause the mechanism to become misaligned. [. . . ] Mounting in the Trunk Make sure the mounting angle of the Shuttle installation will fall within the five preset positions (22. If you wish to install it at any other angle, change the spring configuration as shown. Remove the covers provided at both left and right sides of the unit by pressing claws of the covers in the direction shown by the arrow. Use the figure to determine which spring position would be best suited for your chosen mounting location. If the spring configuration is incorrect or the spring positions on the left and right sides are not the same, the shock absorbing mechanism will not function properly. This will prevent the CD Shuttle from operating at its best. Mount the covers at the left and right sides as they were attached originally. Change the switch position using a small screwdriver or other pointed object. CAUTION: When switching the Bus Selector Switch, make sure there are no cables attached to the CHA-S614. Make sure that the "L" type connector of the Ai-NET cable is attached to the Controller and the straight connector is attached to the CHA-S614. The input connectors are Gray and outputs are Black. Use the corresponding Input/Output ID labels to maintain proper connections when extension cables are used. Use of other than designated parts may damage this unit internally or may not securely install the unit in place as parts that come loose may create hazards. dO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST. A high incidence of moisture or dust that penetrates into this unit may cause smoke or fire. Head unit with Ai-NET capability and Ai-NET Cable (Fig. Proper care of your disc/Entretien des disques compacts/Cuidado adecuado de su disco Use the hexagon washerhead bolts (M4 x 8) to fasten the two "L" type mounting brackets (supplied) to the sides of the CD Shuttle. Hold the disc so you will not leave fingerprints on the surface. if the surface is scratched , it may cause the pickup to skip. Do not affix tape, paper, or gummed labels on the disc. For routine cleaning, wipe the playing surface with a clean, soft cloth from the center of the disc to the outer edge. If the surface is heavily soiled, dampen a clean, soft cloth in a solution of mild neutral detergent before cleaning the disc. [. . . ] Make sure the CD trays are inserted straight to prevent jamming (Fig. Insert the CD magazine 1 all the way into the Shuttle until it locks with the narrow side facing the unit as shown in Fig. After inserting the CD magazine 1, close the CD magazine compartment door by sliding it to the left. 7) Caution: Door must be completely closed and remained closed at all times to prevent dust, water and smoke contaminants from diminishing the overall performance of the CD Shuttle. [. . . ]