User manual ALPINE CHA-S624

[. . . ] Then have the necessary parts ready before you begin installation. NOTE: For the vertical installation be sure to install the Shuttle with the CD magazine slot facing upward. Installation of Shuttle With the CHA-S624, CDs are automatically removed from and reinserted into the CD magazine, DO NOT mount the unit upside down, as this could cause the mechanism to become misaligned. CAUTION: Do not install the Shuttle near the vehicle's fuel tank. [. . . ] If the spring configuration is incorrect or the spring positions on the left and right sides are not the same, the shock absorbing mechanism will not function properly. This will prevent the CD Shuttle from operating at its best. Mount the covers at the left and right sides as they were attached originally. 1: Analog output, 2: Digital output With the system not using the digital output, be sure to set the switch to "1" position. Make sure that the "L" type connector of the Ai-NET cable is attached to the Controller and the straight connector is attached to the CHA-S624. 3 Digital Output Terminal This terminal may be used to connect the CHA-S624 to other Alpine digital products, incorporating optical digital inputs. These products include a fiber optic cable that will plug directly into the Digital Output Terminal of the CHA-S624. The input connectors are Gray and outputs are Black. Use the corresponding Input/Output ID labels to maintain proper connections when extension cables are used. In combination with products not using optical digital system (Fig. 3) · In combination with products using optical digital system (Fig. 4) 5 Ai-NET Input Connector 6 Head Unit , etc. With Ai-NET System 7 Optical Digital Unit with Ai-NET System 8 Digital/Analog Switch Position: 1 9 Digital/Analog Switch Position: 2 !Fiber Optic Cable (Included in the another factory unit or sold separately 4915/4916) q Cautions for Connections · Head unit with Ai-NET capability and Ai-NET Cable (Fig. Use of other than designated parts may damage this unit internally or may not securely install the unit in place as parts that come loose may create hazards. dO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST. A high incidence of moisture or dust that penetrates into this unit may cause smoke or fire. Proper care of your disc/Entretien des disques compacts/Cuidado adecuado de su disco Use the hexagon washerhead bolts (M4 x 8) to fasten the two "L" type mounting brackets (supplied) to the sides of the CD Shuttle. Do not allow any cables in the vehicle to come into contact with the unit. It is possible, the constant vibration and movement in the vehicle can cause the cable's insulation to wear through. Hold the disc so you will not leave fingerprints on the surface. if the surface is scratched , it may cause the pickup to skip. [. . . ] Make sure the CD trays are inserted straight to prevent jamming (Fig. Insert the CD magazine 1 all the way into the Shuttle until it locks with the narrow side facing the unit as shown in Fig. After inserting the CD magazine 1, close the CD magazine compartment door by sliding it to the left. 7) Caution: Door must be completely closed and remained closed at all times to prevent dust, water and smoke contaminants from diminishing the overall performance of the CD Shuttle. [. . . ]