User manual ALPINE CHM-S620

[. . . ] Then have the necessary parts ready before you begin installation. NOTE: For the vertical installation be sure to install the Shuttle with the CD magazine slot facing upward. IMPORTANT Please record the serial number of your unit in the space provided here and keep it as a permanent record. Installation of Shuttle With the CHM-S620, CDs are automatically removed from and reinserted into the CD magazine, DO NOT mount the unit upside down, as this could cause the mechanism to become misaligned. [. . . ] This will prevent the CD Shuttle from operating at its best. NOTE: After setting the spring position, put on the label covers on the cutouts at both sides. CAUTION: Do not allow the vehicle's cable to come into contact with the unit. If the vehicle's cable touches the unit, the insulation sheath of the cable may wear out by vibration of the vehicle movement and cause short-circuit. route the cables adequately away from the unit. Connections q The CHM-S620 CD Shuttle is not equipped with builtin control unit and power amplifier. Consult your authorized Alpine dealer for connections of your control unit and power amplifier. NOTE: The CHM-S620 is designed for 12-volt DC negative ground operation so make sure that your vehicle has this system before making electrical connections. 1 8-pin DIN Connector Connect this to your control unit or changer control input of your Alpine Shuttle-ready head unit. to prevent external noise from entering the audio system · Locate the unit and route the leads at least 10 cm away from the car harness. Keep the battery power leads as far away from other leads as possible. Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis. If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information. Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. Use of other than designated parts may damage this unit internally or may not securely install the unit in place as parts that come loose may create hazards. dO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST. A high incidence of moisture or dust that penetrates into this unit may cause smoke or fire. Proper care of your disc/Entretien des disques compacts/Cuidado adecuado de su disco Use the hexagon washer-head bolts (M4 x 8) to fasten the two "L" type mounting brackets (supplied) to the sides of the CD Shuttle. Hold the disc so you will not leave fingerprints on the surface. if the surface is scratched , it may cause the pickup to skip. Do not affix tape, paper, or gummed labels on the disc. [. . . ] Make sure the CD trays are inserted straight to prevent jamming (Fig. Insert the CD magazine 1 all the way into the Shuttle until it locks with the narrow side facing the unit as shown in Fig. After inserting the CD magazine 1, close the CD magazine compartment door by sliding it to the left. 7) Caution: Door must be completely closed and remained closed at all times to prevent dust, water and smoke contaminants from diminishing the overall performance of the CD Shuttle. [. . . ]