User manual ALPINE CHM-S630

[. . . ] Please read this manual to maximize your enjoyment of the outstanding performance and feature capabilities of the equipment, then retain the manual for future reference. Refer to the Connections and Operation sections before you proceed with installation. install the Shuttle properly using the "L" type brackets supplied. Improper installation can degrade performance (causing the player to skip, mis-track, etc. [. . . ] Failure to heed them can result in injury or material property damage. uSE SPECIFIED ACCESSORY PARTS AND INSTALL THEM SECURELY. Be sure to use only the specified accessory parts. Use of other than designated parts may damage this unit internally or may not securely install the unit in place. This may cause parts to become loose resulting in hazards or product failure. dO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST. Avoid installing the unit in locations with high incidence of moisture or dust. Moisture or dust that penetrates into this unit may result in product failure. CAUTION: Do not allow any of the vehicle's cable to come into contact with the unit. If a cable touches the unit, the constant vibration of the vehicle's movement can cause the insulation to wear out. Connections G The CHM-S630 CD Shuttle is not equipped with builtin control unit and power amplifier. Consult your authorized Alpine dealer for connections of your control unit and power amplifier. NOTE: The CHM-S630 is designed for 12-volt DC negative ground operation so make sure that your vehicle has this system before making electrical connections. 1 8-pin DIN Connector Connect this to your control unit or changer control input of your Alpine Shuttle-ready head unit. to prevent external noise from entering the audio system · Locate the unit and route the leads at least 10 cm away from the car harness. Keep the battery power leads as far away from other leads as possible. Connect the ground lead securely to a bare, metal spot of the car's chassis. If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information. Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. You can play CD-Rs (CD-Recordable)/CD-RWs (CD-ReWritable) for audio use on this unit. Some of the following CDs may not play on this unit: Flawed CDs, CDs with fingerprints, CDs exposed to extreme temperatures or sunlight (e. [. . . ] The outer and inner edges should be round and smooth. Use of irregularly shaped discs may cause damage to the mechanism. First, insert the Hexagon bolts (M6 x 25) up through the holes in the bottom of the floor base plates. The bolt heads should be recessed into the hole under the base plate so the base lays flat on the floor. [. . . ]