User manual ALPINE CXA-B200NK

[. . . ] technical Requirements Alpine Car Radios Supported The MobileHubTM is designed for operation with all Alpine car radio systems compatible to the Ai-Net (since 1998). If you are using the CDA-7998R, you will be able to utilize the full range of hands-free feature. Nokia Mobile Phones Supported The MobileHubTM may be used with the following mobile phones: Nokia 5110, Nokia 5130 Nokia 6110, Nokia 6130, Nokia 6150 Nokia 6210 Nokia 6310 Important Notes The instructions contained in this installation guide are general guidelines which apply for the installation of the MobileHubTM in an automobile. However, due to the wide variety of car types and models available on the market, this guide cannot consider the individual technical requirements relevant for any particular automobile. [. . . ] With the engine switched off, as this may cause your battery to run dry. Your MobileHubTM for Nokia Handsets The MobileHubTM you have purchased is designed to integrate your mobile phone in the Alpine car radio system installed your car. Please read the basic safety guidelines set out below before beginning any installation work. CAUTION Disconnect the car battery before beginning with the installation work and make sure that it cannot be reconnected inadvertently. Make sure that there is no source of fire or flame nearby. In order to comply with RF exposure requirements for mobile transmitting devices, a minimum distance of 20 cm must be maintained between the antenna and all persons. Mounting Instructions 1 Advanced active car holder MCC-1 Should you wish to operate your Nokia mobile phone using the phone's key pad, position the active swivel holder so that the phone display is clearly visible and the keys easy to reach from the driver's seat. connect the wires to the MobileHub TM as depicted in the illustration. 2 Mounting plate MKU-1 Use the screws supplied in the KHH-S9 kit and the MKU-1 mounting plate to fix the mobile phone holder in the car interior. Select a suitable location on the dashboard or console, making sure that the unit does not impair the driver when operating the vehicle. 3 MobileHubTM for Nokia Handsets CXA-B200NK Use the screws supplied to mount the MobileHubTM in a suitable location which will allow the cables to be connected at the sides of the device. 30 cm from the driver's head and position it so that it points towards the driver's mouth. Experience has shown that the best locations are near the rearview mirror or to the left of the sun visor. Make sure to keep the microphone at least 1 m away from the radio loudspeakers to avoid feedback. Take care to mount the microphone so that it is not exposed to air streams from the ventilators. do not lay the microphone cable in the heating , ventilation , or AC system. Use the adhesive tape supplied to fix the microphone as it prevents noise from the car body being transmitted into the interior. You will hear the person you are talking to on your mobile phone over the Alpine car radio loudspeakers. When you accept an incoming call or an outgoing call is connected, the car radio automatically mutes the audio source (music) and the call is switched over to the loudspeakers. 5 GSM Antenna (not included in the scope of supply) Your MobileHubTM is designed to be connected to an external GSM antenna. [. . . ] When testing the function of the kit, also check that it in no way impairs the driver during operation of the vehicle. Operation With the MobileHubTM, you can choose to operate your Nokia mobile phone using the phone's key pad or over the Alpine car radio or navigation system. All phone calls made while the mobile phone is in its holder will only run over the hands-free microphone with voice output over the car radio loudspeakers. For information on the operation of your mobile phone, please refer to the Nokia User's Guide supplied with the phone. [. . . ]