User manual ALPINE HCE-C115

[. . . ] CONNECT LEADS PROPERLY Be sure to connect the color coded leads according to the diagram. Incorrect connections may cause the unit to malfunction or cause damage to the vehicle's electrical system. Return it to your authorized Alpine dealer or the nearest Alpine Service Center for repairing. Doing so could cause the strength of the camera mounting to weaken, which could cause it to fall of and cause accidents, injury, or damage to the car body. [. . . ] uSE THIS PRODUCT FOR MOBILE 12 VOLT APPLICATIONS. Use for other than its designed application may result in fire, electric shock or other injury. About Care of Device Do not assert any excess pressure to the camera or the mounting, as this could cause the camera direction to shift, or the camera mounting bracket to come off. To prevent the camera lens, mounting and cords from changing color or shape, or from deteriorating, wipe with a chemical-free, damp cloth. When washing the car, do not using an automatic car washer, or highpressure washer. Doing so could cause the camera to come off, damage to the device cord, or may allow water to enter the camera or the inside of the car. In some cases, to attach the device, a hole must be drilled in the car body, requiring use of touch-up paint (retail product) for rust-prevention, and should be prepared beforehand. Be sure to disconnect the cable from the (­) battery post before installing your HCE-C115. This will reduce any chance of damage to the unit in case of a short-circuit. Be sure to connect the color coded leads according to the diagram. Incorrect connections may cause the unit to malfunction or damage to the vehicle's electrical system. When making connections to the vehicle's electrical system, be aware of the factory installed components (e. Do not tap into these leads to provide power for this unit. When connecting the HCE-C115 to the fuse box, make sure the fuse for the intended circuit of the HCEC115 has the appropriate amperage. Failure to do so may result in damage to the unit and/or the vehicle. When in doubt, consult your Alpine dealer. About Rear Camera The rear camera of this camera system is a dedicated product. About Power Connection Connect a reverse input cable (orange/white) to the power cable of the rear lamp. for details , consult a dealer purchased camera , or car dealer. Connect this to a power cable of the rear lamp, but not to the positive of the rear lamp signal cable. Do not use mobile phones and wireless devices near the camera. Doing so may result in noise on the screen or malfunction. [. . . ] Waterproof securely the hole made for the camera cable using a commercially-available waterproof tape or sealing material. If necessary, use a self-tapping screw L to fix the camera mounting bracket (In the case of a plastic mount area). Anslut denna ledning till den positiva sidan för strömmatningen till backlampan, eller ACC-läget. When adjusting the camera angle, do so after turning off the engine and applying the hand brake to avoid an accident. [. . . ]