User manual ALPINE HCE-C155

[. . . ] Use of other than designated parts may damage this unit internally or may not securely install the unit in place. This may cause parts to become loose resulting in hazards or product failure. CONNECT LEADS PROPERLY Be sure to connect the colour coded leads according to the diagram. Incorrect connections may cause the unit to malfunction or cause damage to the vehicle’s electrical system. [. . . ] € NOTICE • About Care of Device Do not assert any excess pressure to the camera or the mounting, as this could cause the camera direction to shift, or the camera mounting bracket to come off. To prevent the camera lens, mounting and cords from changing colour or shape, or from deteriorating, wipe with a chemical-free, damp cloth. When washing the car, do not using an automatic car washer, or highpressure washer. Doing so could cause the camera to come off, damage to the device cord, or may allow water to enter the camera or the inside of the car. In some cases, to attach the device, a hole must be drilled in the car body, requiring use of touch-up paint (retail product) for rust-prevention, and should be prepared beforehand. Be sure to disconnect the cable from the (–) battery post before installing your HCE-C155. This will reduce any chance of damage to the unit in case of a short-circuit. Be sure to connect the colour coded leads according to the diagram. Incorrect connections may cause the unit to malfunction or damage to the vehicle’s electrical system. When making connections to the vehicle’s electrical system, be aware of the factory installed components (e. Do not tap into these leads to provide power for this unit. When connecting the HCE-C155 to the fuse box, make sure the fuse for the intended circuit of the HCEC155 has the appropriate amperage. Failure to do so may result in damage to the unit and/or the vehicle. When in doubt, consult your Alpine dealer. About Rear Camera The rear camera of this camera system is a dedicated product. About Power Connection Connect a reverse input cable (orange/white) to the power cable of the rear lamp. for details , consult a dealer purchased camera , or car dealer. Connect this to a power cable of the rear lamp, but not to the positive of the rear lamp signal cable. Do not use mobile phones and wireless devices near the camera. Doing so may result in noise on the screen or malfunction. It is recommended to use mobile phones or wireless devices away from the camera. About Camera Installation Location Before installing, make sure there is a enough space to be able to install the camera. [. . . ] failure to do so may cause a malfunction. D Reverse/ACC Lead Orange/ white 1 Put the gear shift into reverse (R), and check the image from the camera on the display. 2 Loosen the camera mounting bracket C and angle adjustment screw. Determine the camera angle, and carefully tighten the angle adjustment screw. [. . . ]