User manual ALPINE MDA-7755R

[. . . ] Make sure the MDA-7755R will not be installed in a location subjected to: · Never open the Shutter (window) on the MD cartridge and touch the disc inside the cartridge. Place only 1 label at proper location on the MD. Make sure MDs are clean before inserting into the changer. If the vehicle room is warmed up quickly, moisture condensation may form on the pickup lens preventing proper operation. [. . . ] Each press changes the display patterns as shown on page 17. Spectrum Analizer Pattern Peak Hold Pattern Peak Value lncreasing Pattern Block Pattern Peak Value Increasing Block Pattern Mirror Pattern Spectrum Analizer Dual Stack Pattern Scan Display (Repeats from Pattern 1 to Pattern 2 for 5 seconds each continuously. To close the display panel, push the display panel until it is firmly closed and a click sound is heard. notes: · When the display panel is opened, do not place any thing on top of the panel and take care not to bump or apply pressure to the panel. If the temperature inside the vehicle is low, the LCD display will be darker than normal when the unit is turned on. When the temperature goes up to within the operational temperature range for the LCD display, the display automatically returns to normal brightness. ⷠBefore operating this unit, be sure to read the Owner's Manuals for your control unit etc. The MD compartments are located behind the display panel. Insert an MD into one of the compartments with the label side facing up and the arrow mark toward the compartment. The compartment number ( ) indicator lights up indicating that the MD is loaded. There are 3 compartments, load only one MD into one compartment. Press and hold the g or f button to quickly move backward or forward until you reach the desired section of the track. Press the REPEAT button to display "RPT" (Repeat) or "RPT ALL" (Repeat all) to play back repeatedly the current track being played or the entire disc selected. Note: Single track cannot be repeated during M. To cancel repeat play, press the REPEAT button again until both the RPT and ALL indicators disappear. On mode, all the tracks on the MD being played will be played back in a random sequence. Note: When all the tracks on the current MD have been played back once, the canger automatically goes to the next MD and plays it in a random sequence. The first 10 seconds of each track will be played back in succession. The display will change each time you press the button as follows. If the MD title or track name is longer than 16 characters, press the SCROLL button. It will display the entire title by scrolling 1 character at a time to the left in the display. After displaying the last character for 3 seconds, the display return to the normal mode. [. . . ] If you encounter a problem, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer. ­ If connected following instructions, the unit will not operate with the vehicle's ignition off. [. . . ]