User manual ALPINE MRP-M350

[. . . ] Always stop the vehicle in a safe location before performing these functions. Doing so may result in an accident, fire or electric shock. Use for other than its designed application may result in fire, electric shock or other injury. Doing so may cause heat to build up inside and may result in fire. [. . . ] NOTE: To securely connect the ground lead, use an already installed screw on the metal part of the vehicle (marked (#)). Be sure this is a good ground by checking continuity to the battery (­) terminal. As much as possible connect all equipment to the same ground point. Before making connections, be sure to turn the power off to all audio components. Connect the yellow battery lead from the amp directly to the positive (+) terminal of the vehicle's battery. Do not connect this lead to the fuse block. Locate the unit and route the leads at least 10 cm away from the car harness. Keep the battery power leads as far away from other leads as possible. Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis. If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information. Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. 1 RCA Input Jacks to the line out leads on your 1 Prises d'entréeprises aux conducteurs de sortie de 1 Clavijas las mismas a los cables de salida de línea RCA RCA de entrada Connect these jacks Connecter ces Conecte 2 Speaker Output has one set of speaker outputs. be 2 Terminals The MRP-M350 Sure to observe correct speaker output connections and phasing in relation to the other speakers in the system. Do not connect speaker leads together or to chassis ground. Battery Lead (Yellow) (Sold Separately) Be sure to add a 40 amp fuse as close as possible to the battery's positive (+) terminal. This fuse will protect your vehicle's electrical system in case of a short circuit. If you need to extend this lead, the wire gauge should be 8 AWG or larger. Head unit using RCA extension cables (sold separately). Be sure to observe correct channel connections; Left to Left and Right to Right. 4 Remote Turn-On Lead (Blue/White) (Sold Sepa- 4 rately) 5 Ground Leadlead securely to Separately) metal spot 5 (Black) (Sold Connect this a clean, bare on the vehicle's chassis. Verify this point to be a true ground by checking for continuity between that point and the negative (­) terminal of the vehicle's battery. [. . . ] 6 Important Tips on Bridging an Amplifier/Conseils importants lors de la mise en pont d'un amplificateur/Consejos importantes cuando conecte en puente un amplificador NOTE: The following problem may occur if the amp is not properly connected. Low output when only one input is used. # Use either RCA line level or speaker level inputs. NOTE/REMARQUE/NOTA: When making the connection with the speaker input lead, refer to the system shown in Fig. [. . . ]