User manual ALPINE NVE-N055PS

[. . . ] R R 1 DIN Voice Guidance Navigation System ALPINE ELECTRONICS, INC. Tokyo office: 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan Tel. : (03) 3494-1101 ALPINE ELECTRONICS OF AMERICA, INC. 19145 Gramercy Place, Torrance, California 90501, U. S. A. Tel. : 1-800-ALPINE-1 (1-800-257-4631) 1-888-NAV-HELP (1-888-628-4357) ALPINE ELECTRONICS OF CANADA, INC. [. . . ] calculating position · Blue . . . . . two-dimensional position calculation · Green . . three-dimensional position calculation · None . . . . position not being calculated/cannot be calculated RE TU RN M T E P O S . U R LO O . P T . O N O F F Names of the Parts and Their Functions LIGHT button When this button is pressed, the MENU, RETURN, VOICE and buttons light up for 5 seconds. (Narrow range display) button Press to switch between the map and guide (with arrow) modes. ZOOM buttons (5, 6) 5 Change the map magnification ratio upward or downward. (Wide range display) POS. (Position) button Returns to the current position of your vehicle or displays the latitude/ longitude. LO. PT. (Local Point) button Pressing this button displays the current position of the vehicle or local interest points in the vicinity. When this button is pressed, the selection menu for the displayed local points will appear in the display. POS. Tips If you press the POS. button while you are travelling on an arterial road, the latitude/longitude and the name of that arterial road are displayed. 11 Before using this system Before Using This System Main unit Power indicator Lights up when the power is on for the main unit. a Keep the sliding door closed except when changing the disc. a Before inserting or removing a disc, always turn the ignition key to the ACC or ON position. You cannot remove or insert the disc with the ignition key turned to the OFF position. a Do not insert any music CDs or older version of map CD ROMs. CA R NA VIG AT IO N SY ST EM NV E-N 055 PS Tips Sliding door Access indicator Lights up while the CD-ROM is being accessed. Inserting a disc 1 Slide the door down. If a disc is already in the navigation system, the disc will be automatically ejected part way. 3 Close the door when the disc has been pulled into the system. CA R NA VI GAT IO N SY ST EM CA R NA VI GAT IO N SY ST NV EM E-N NV E-N 055P 055P S S 2 Insert the CD ROM (sold separately) with the label side facing up. When you insert the disc to a certain position, it is automatically pulled into the navigation system. Removing a disc 1 Slide down the door. The disc will be automatically ejected part way. Take it out and slide up the door. CA CA R NA VIG R NA VIG ATI ATI ON ON SY SY STE STE M M NV E-N NV 055 E-N PS 055 PS Note: If the disc is left part way ejected, the disc will be automatically pulled into the system. Do not touch the surface of the disc directly with your fingers. 12 Tips Precautions for the remote control a This device is lightweight and compact. Doing so could break it, speed up battery wear, or cause malfunction. a To clean this device, wipe it off with a dry cloth. (If it is extremely dirty, wipe it off with a damp cloth that has been carefully wrung out. ) Never use benzene, paint thinner or harsh chemicals. They cause deterioration of the case and paint. Do not leave this remote control on the dashboard or anywhere else subject to direct sunlight. Tips Replacing the batteries Use two AAA-type batteries. 1 Open the cover 2 Replace the batteries 3 Close the cover Before Using this System While pushing on the cover slightly forcefully, remove it in the direction indicated by the arrow. Take out the old batteries and put the new ones into the remote control with correct polarities as indicated in the battery compartment. Push the cover into place in the direction of the arrow until it clicks closed. e d e d 13 Before using this system Switching the display on/off With this system, when the display monitor is set in the navigation display mode or external input display mode and the ignition key is turned to the ACC or ON positions, the opening screen will automatically appear. 1-1 1-2 After the opening screen is displayed, important information saying "Please be sure to read this!" is displayed. If the language has not been selected yet, the language selection menu is displayed. Select (highlight) the desired language by tilting the joystick. Then press the ENTER button. ENTER 2 After you have read this important information, press the ENTER button. The map screen is displayed. ENTER 3 With the map displayed, press the OFF button to turn off the monitor. If you press the ON button, the opening screen is displayed. OFF Tips 14 a If there is no disc in the navigation system, "Please insert map CD ROM" is displayed. For details on how to load the disc, see "Inserting a disc" and "Removing a disc" on page 12. [. . . ] · The right to use the Disk and Database shall expire either when the user destroys this software, or when any of the terms for use is violated and Aisin AW, Alpine and/or TELE ATLAS exercises the option to revoke the license to use this software. · The terms and conditions hereof apply to all subsequent users and owners as well as to the actual purchaser. WARNING · Operation of the system while driving is dangerous. Users should stop vehicle before operating the software. · Road conditions and regulations take precedence over information contained on the map display: observe actual traffic restrictions and circumstances while driving. [. . . ]