User manual ALPINE NVE-N077P

[. . . ] R R Voice Navigation System ALPINE ELECTRONICS, INC. Tokyo office: 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan Tel. : (03) 3494-1101 ALPINE ELECTRONICS OF AMERICA, INC. 19145 Gramercy Place, Torrance, California 90501, U. S. A. Tel. : 1-800-ALPINE-1 (1-800-257-4631) 1-888-NAV-HELP (1-888-628-4357) ALPINE ELECTRONICS OF CANADA, INC. [. . . ] If wiring passes through a hole in metal, use a rubber grommet to prevent the wire's insulation from being cut by the metal edge of the hole. HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS. The wiring and installation of this unit requires special technical skill and experience. To ensure safety, always contact the dealer where you purchased this product to have the work done. USE SPECIFIED ACCESSORY PARTS AND INSTALL THEM SECURELY. Be sure to use only the specified accessory parts. Use of other than designated parts may damage this unit internally or may not securely install the unit in place. This may cause parts to become loose resulting in hazards or product failure. DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST. Avoid installing the unit in locations with high incidence of moisture or dust. Moisture or dust that penetrates into this unit may result in product failure. Precautions IMPORTANT Please record the serial number of your unit in the space provided on the back cover of Owner's Manual and keep it as a permanent record. The serial number plate is located on the bottom of the unit. · For installation of the main unit, avoid areas with a high incidence of dust or moisture. Installing the unit in such locations may result in contamination of the DVD ROM making it unreadable. · Do not install the navigation system near a CD player that may interfere with GPS signal reception. · The optimum locations for installing the GPS aerial are: ­ on the dashboard where no metal piece (such as the defogger wire or aerial wire) is located on the windshield. · Route the Speed Pulse Sensor cable away from the audio cables in order to avoid picking up noises. 3 Contents PRECAUTIONS 1. NVE-N077PS Wiring Diagram With CVA-1003R/TME-M750 3-2. NVE-N077PS Wiring Diagram With IVX-C806/IVA-C800R/ IVX-M706/IVA-M700R/CVA-1006R/CVA-1005R 3-3. NVE-N077PS Wiring Diagram With CVA-1000R 3-4. NVE-N077PS Wiring Diagram With TME-M006SP/TME-M005P 3. Confirmation 2 5 6 7 8 9 10 11 12 4 1. [. . . ] Mounting Note: The main unit must be mounted within ±5 degrees of the horizontal plane, left to right, and 30 degrees of the horizontal plane, back to front. 2 Attach the unit on the rear tray. Attach the unit securely with hex bolts (M6×50) 4, flanged hex nuts (M6) 7, spring washers (M6) 6, and wing nuts (M6) 8. Continued to step 5 "Securing leads, etc. " 4 Less than 30° aWhen mounting using Velcro fastener 1 2 Place Velcro fasteners. Place two pieces of Velcro fasteners onto the mounting surface. [. . . ]