User manual ALPINE PDX-4.100 Owners Manual

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ALPINE PDX-4.100. We hope that this ALPINE PDX-4.100 user guide will be useful to you.

Lastmanuals help download the user guide ALPINE PDX-4.100.


Mode d'emploi ALPINE PDX-4.100
Download
Manual abstract: user guide ALPINE PDX-4.100Owners Manual

Detailed instructions for use are in the User's Guide.

[. . . ] ENGLISH R FRANÇAIS Introduction : Prière de lire attentivement ce MODE D'EMPLOI pour se familiariser avec chaque commande et fonction. Chez Alpine, nous espérons que le nouveau PDX-4. 100 donnera de nombreuses années de plaisir d'écoute. En cas de problèmes lors de l'installation du PDX-4. 100, prière de contacter le revendeur agréé d'ALPINE. PRECAUTION : Ces commandes sont utilisées pour la syntonisation du système. [. . . ] Remove the four corner top caps on top using the hexagon wrench (large, supplied). Fasten the unit down with the four self-tapping screws (M4 x 40, supplied). Refer to fig. 2. NOTE: A magnetic screwdriver is recommended to prevent the screw being dropped while tightening. Re-attach the four top caps and hand-tighten. Firstly, securely install one unit, as described in steps 1-3 of A above. Attach the four joint caps (supplied with connected amplifier) in the four corners of the first unit with 2 machine screws (M2. 6 x 14, supplied with connected amplifier) per each cap. Stack the second unit on top of the installed unit, aligning the second unit's feet with the joint caps of the first unit. Remove the four corner top caps of the second unit using the hexagon wrench (large, supplied). Insert the four machine screws (M4 x 36, supplied with connected amplifier) through the top of the second unit into the four joint caps of the lower unit to connect them together. Re-attach the four top caps and hand-tighten. 4 Fig. 3 Top Cap/Capuchon supérieur/Tapon superior 3 3 Machine Screw (M4 x 36)/ Vis mécanique/ Tornillo mecánico 4 Joint Cap/ Capuchon de joint/ Tapon de junta Second unit/ Deuxième unité/ Segunda unidad 4 4 First unit/ première unité/ Primera unidad Fig. Firstly, securely install the first two units firmly as described in steps 1 to 5 of B above. Next, install the third unit as described for the second unit in B above. With this, stack installation of the 3 units is completed. CONNECTIONS/CONNEXIONS/CONEXIONES 1 2 3 4 CONNECTIONS (Fig. 8) Before making connections, be sure to turn the power off to all audio components. Connect the yellow battery lead from the amp directly to the positive (+) terminal of the vehicle's battery. Do not connect this lead to the fuse block. CAUTION x Caution on connection terminals/parts · Do not allow other objects (particularly electrically conductive) to get too close or in contact with any of the unit's terminals/parts (power supply, fuse, speaker output terminal, RCA connector, etc. ). Doing so may result in short circuit or accident. To prevent external noise from entering the audio system. · Locate the unit and route the leads at least 10 cm (3-15/16") away from the car harness. · Keep the battery power leads as far away from other leads as possible. [. . . ] 10 4 7 5 8 TYPICAL SYSTEM CONNECTIONS/CONNEXIONS TYPIQUES DU SYSTEME/CONEXIONES TIPICAS DEL SISTEMA [English] , Center Speaker (sold separately) - Front Left Speaker (sold separately) . Front Right Speaker (sold separately) / Rear Left Speaker (sold separately) : Rear Right Speaker (sold separately) ; Subwoofer (sold separately) < RCA Extension Cable (sold separately) = Fiber Optic Cable (sold separately) NOTES: Please observe the following when using Fiber Optic Cable. · Do not coil the Fiber Optic Cable smaller than a 30 mm (1-3/16') radius. · Do not place anything on top of the Fiber Optic Cable. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ALPINE PDX-4.100

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ALPINE PDX-4.100 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag