User manual ALPINE PDX-4.150

[. . . ] ENGLISH R FRANÇAIS Introduction: Prière de lire attentivement ce MODE D'EMPLOI pour se familiariser avec chaque commande et fonction. Chez Alpine, nous espérons que le nouveau PDX-4. 150 donnera de nombreuses années de plaisir d'écoute. En cas de problèmes lors de l'installation du PDX-4. 150, prière de contacter le revendeur agréé d'ALPINE. PRECAUTION: Ces commandes sont utilisées pour la syntonisation du système. [. . . ] Make sure there are no objects behind the surface that may become damaged during drilling. Position the PDX-4. 150 over the screw holes, and secure with four self-tapping screws. NOTE: To securely connect the ground lead, use an already installed screw on the metal part of the vehicle (marked ). Be sure this is a good ground by checking continuity to the battery (­) terminal. As much as possible connect all equipment to the same ground point. These procedures will help eliminate noise. Position the unit over the screw holes you prepared earlier. Remove the four corner top caps on top using the hexagon wrench (large, supplied). Fasten the unit down with the four self-tapping screws (M4 x 40, supplied). Refer to fig. 2. Re-attach the four top caps securely using the hexagon wrench. Firstly, securely install one unit, as described in steps 1-3 of A above. Attach the four joint caps in the four corners of the first unit with 2 machine screws (M2. 6 x 14, supplied) per each cap. Stack the second unit on top of the installed unit, aligning the second unit's feet with the joint caps of the first unit. Remove the four corner top caps of the second unit using the hexagon wrench (large, supplied). Insert the four machine screws (M4 x 36, supplied) through the top of the second unit into the four joint caps of the lower unit to connect them together. Re-attach the four top caps to the second unit using the hexagon wrench (big, supplied). Firstly, securely install the first two units firmly as described in steps 1 to 5 of B above. Next, install the third unit as described for the second unit in B above. With this, stack installation of the 3 units is completed. Second unit/Deuxième unité / Segunda unidad 2 2 First unit/première unité / Primera unidad Fig. 4 1 2 3 4 CONNECTIONS (Fig. 8) Before making connections, be sure to turn the power off to all audio components. Connect the yellow battery lead from the amp directly to the positive (+) terminal of the vehicle's battery. [. . . ] Front Right Speaker (sold separately) / Rear Left Speaker (sold separately) : Rear Right Speaker (sold separately) ; Subwoofer (sold separately) < RCA Extension Cable (sold separately) = Fiber Optic Cable (sold separately) NOTES: Please observe the following when using Fiber Optic Cable. · Do not coil the Fiber Optic Cable smaller than a 30 mm (1-3/16') radius. · Do not place anything on top of the Fiber Optic Cable. @ Y-Adaptor (sold separately) [Français] , Haut-parleur central (vendu séparément) - Haut-parleur avant gauche (vendu séparément) . [. . . ]