User manual ALPINE PXA-H510

[. . . ] OWNER'S MANUAL Please read this manual to maximize your enjoyment of the outstanding performance and feature capabilities of the equipment, then retain the manual for future reference. The exclamation point within an equilateral triangle and "WARNING" are intended to alert the user to the presence of important operating instructions. Doing so may lead to accident, fire or electric shock. When problems occur such as a lack of sound or video, foreign objects inside the unit, smoke coming out, or noxious odors, stop use immediately and contact the dealer where you bought the equipment. [. . . ] Time correction eliminates the differences in the time required for the sound to reach the listening position. the time of the front right speaker is corrected by 5. 1 ms so that its sound reaches the listening position at the same time as the sound of other speakers. Within 5 seconds, press "BAND" and select the speaker to be adjusted. (FL: Front left, FR: Front right, RL: Rear left, RR: Rear right, SW: Subwoofer) Notes: · The rear speakers cannot be adjusted if they are set to the off mode. The subwoofer cannot be adjusted if it is set to the off mode. refer to "Turning the subwoofer on and off" (page 14). Within 5 seconds, use the " " or " " key to adjust the time correction. This time correction function cannot be used with the center speaker. After this procedure is completed, use the "Rear speaker time correction" function (page 50) as desired to achieve a sound with an even greater sense of presence. This function is for processing audio signals recorded onto two channels into Dolby Pro Logic surround signals. When " " is pressed, the off mode is set. Note: The operation in step 2 above cannot be performed when Dolby Digital signals are being input. When you want to enjoy sound of Dolby Digital system in the PROLOGIC mode, set the mode to "LPCM" in "Digital Output Setting" of the DVD player. Sound volume in the digital mode and PROLOGIC mode may differ with the sound volume in the OFF mode, depending on the settings and softeners to be playedback. In this case, adjust the "Speaker Level" in the digital mode and PROLOGIC mode so that the sound difference does not occur. Setting the speaker mode (page 38) Adjusting the speaker level (page 42) Center speaker time correction (page 46) Rear speaker time correction (page 50) Simulating a center speaker (page 54) Mixing the rear audio channels (page 58) Achieving powerful sound at low volumes (page 62) Information: The surround sound adjustments (pages 66 and 68) cannot be made when the audio mode indicator is lit. The PXA-H510 can be set according to the frequency reproduction range of the speakers being used. Check the frequency reproduction range of the speakers before performing this operation. Use the " " or " " key to select the "SPEAKER" (speaker selection) mode. In this mode set the properties of the speakers and whether or not speakers are connected. Within 5 seconds, press "BAND" and select the speaker(s) to be adjusted. [. . . ] Once the settings you want to store in the memory have been adjusted, press "A. Within 5 seconds, use the " " or " " key to select the number at which you want to store the settings ("MEMO1" to "MEMO6"). Within 5 seconds, press "ENT". Within 5 seconds, use the " " or " " key to select the number of the memory you want to recall ("MEMO1" to "MEMO6"). [. . . ]