User manual ALPINE PXA-H900

[. . . ] R PXA-H900 Multimedia ManagerTM Guide for Installation and Connections Hinweise über die Installation und Anschlüsse Guide d'installation et de connexions Guía de instalación y conexiones Guida all'installazione ed ai collegamenti Vägledning för montering och anslutningar English Deutsch Français Español Italiano Svenska PRECAUTIONS GUIDE FOR INSTALLATION AND CONNECTIONS · Please read this GUIDE FOR INSTALLATION AND CONNECTIONS and the OWNER'S MANUAL thoroughly to familiarize yourself with each control and function. We at ALPINE hope that your new PXA-H900 will give you many years of listening enjoyment. In case of problems when installing your unit, please contact your authorized ALPINE dealer. Points to Observe for Safe Usage · Read this manual carefully before starting operation and use this system safely. We cannot be responsible for problems resulting from failure to observe the instructions in this manual. [. . . ] Use a screwdriver, etc. , to slide the locking pin, then take out the inner case. Inner case Locking pin 3. Mount the display using the included screws. Bracket Spacer Display Pan head screw (M3 x 5) x 2 4. Mount the previously removed inner case into the dashboard. Dashboard Inner case Face plate 7-EN < JAPANESE CAR > 1. After step 2 on page 7, remove the included side bracket. Side bracket Side bracket 2. Mount the display using the included screws. Bracket Spacer Display Pan head screw (M3 x 5) x 2 3. Mount the spacer and bracket to the display. Next, securely mount the factory brackets removed from the factory radio, to the display assembly. Flat head screws (M5 x 8) Bracket 8-EN · Flush Mounting the display 1. Make a cut-out approximately 178 (width) by 50 (height) mm (7 inches by 2 inches) in size at your desired mounting location. WARNING: When making cut-outs, be careful not to damage pipes, tanks, electric wires, etc. Doing so could lead to accidents or fire. After step 2 on page 7, remove the included side bracket. Remove the spacer from the bracket. Spacer Bracket 4. Mount the spacer on the display using the included screws. Spacer Display Pan head screw (M3 x 5) x 2 5. Attach the flush mount brackets to the display using the included screws. Mount this assembly into the prepared cut-out. Flush mount Self-tapping screw (M2. 6 x 8) x 4 Face plate 9-EN · Mounting the base unit 1. · The trunk, etc. , is the best place. Mark the positions of the mounting screws at the chosen location. WARNING: When making holes, be careful not to damage pipes, tanks, electric wires, etc. Doing so could lead to accidents or fire. [. . . ] Check the thickness of the wires. NOTES · Use wires larger than the PXA-H900's fuse capacity. · Wire sizes usable with the PXA-H900 are AWG8 to AWG10. · If you do not know the thickness of the wires, contact your store of purchase, a service shop or/and Alpine service center. 2. Strip 7 to 10mm (1/4" ­ 3/8") of the wire's insulation. Cord 7 to 10mm (1/4" ­ 3/8") To PXA-H900's lead terminal NOTES · If the exposed section is too short, the current will not flow properly, resulting in the PXA-H900 not operating or breaks in the sound. [. . . ]