User manual ALPINE RUX-4280

[. . . ] This symbol means important instructions. Failure to heed them can result in injury or property damages. Return it to your authorized Alpine dealer or the nearest Alpine Service Center for repairing. Temperature Be sure the temperature inside the vehicle is between +60°C (+140°F) and ­10°C (+14°F) before turning your unit on. [. . . ] 5 ­ 5 MRD-M300: Q = 1 ­ 3 NOTE: This differs according to the amplifier being used. Adjustment Range: MRD-M500: ­12dB ­ +12dB MRD-M300: ­10dB ­ +10dB NOTE: This differs according to the amplifier being used. Turn the rotary encoder until the "ON" message is displayed on the screen. Keep turning the rotary encoder until the "ON" message is displayed on the screen. Keep turning the rotary encoder until the "YES" message is displayed on the screen. Keep turning the rotary encoder until the "YES" message is displayed on the screen. When connecting multiple amplifiers, set this function. Properly setting the turn on timing delay prevents the battery running down. Turn right to increase the turn on delay time · Turn left to decrease the turn on delay time · The power is supplied only to the DSP circuit and it maintains low power consumption. NOTE: The SAFE mode settings made using the above procedure only become valid when the power is turned off then back on. When multiple amplifiers are connected in your system, you can select one of them by pressing the AMP button to adjust its function. The next amplifier comes up on the screen every time your repress the button. NOTE: The display may flicker when multiple amplifiers and controllers are connected. This could be caused by the fact that there are multiple amplifiers with the ID selected by the controller. In this case, set different IDs on the amplifier side. To set AMP NAMING function: You can name the amplifier which is installed in your amplifier system. Repeat steps 3 and 4 and enter the characters to the desired place. CAUTION: Do not install the control center near the air-bag of the front passenger's seat. After determining the installing location, install the flush mount with screws (M2. Insert the control center into the flush mount to lock securely. Insert the control center into the flush mount to lock securely. Insert the control center and flush mount combined into the bracket mount and fix them. [. . . ] If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors. Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. Output power reduction because of high temperature (78°C to 80°C: ­6dB) HOT (at INFO DISP mode) Output power reduction because of high temperature (81°C to 83°C: ­12dB) HI TEMP (at INFO DISP mode) When multiple amplifiers are connected, the power of one of the connected amplifiers may be turned off. [. . . ]