User manual ALPINE TDA-7567R

[. . . ] OWNER'S MANUAL Please read this manual to maximize your enjoyment of the outstanding performance and feature capabilities of the equipment, then retain the manual for future reference. The exclamation point within an equilateral triangle and "WARNING" are intended to alert the user to the presence of important operating instructions. HALT USE IMMEDIATELY IF A PROBEl hacer caso omiso de las instruccioLEM APPEARS nes podría resultar en heridas graves When problems appear, stop using o la muerte. The system immediately and contact the dealer from whom you purchased the equipment. [. . . ] The RDS allows you to receive a variety of information such as traffic information, station names, and to automatically re-tune to a stronger transmitter that is broadcasting the same programme. Note: Use the AF OFF mode when automatic re-tuning is not required. Choose your desired station in 5 seconds after the above step 2. Note: When the BAND button is pressed and held for more than 2 seconds while a station name is displayed, the display shows the station frequency for 5 seconds. When the RDS station signal received has become weak: · AF seek mode, press and hold the F1 button for at least 2 seconds to have the unit automatically seek a stronger station in the AF list. If there is no AF station, the display shows "SEEK END. Note: You can tune in an RDS station while you are listening to cassette play. The display shows "AF" when the AF mode is activated. If the preset station's signal is weak, the unit automatically searches and tunes to a stronger station in the AF (Alternate Frequencies) list. If the preset station and the stations in the AF list cannot be received: The unit searches again for a station in the PI (Programme Identification) list. If there are still no stations receivable in the area, the unit displays the frequency of the preset station and the preset indicator disappears. If the signal level of the Regional (Local) station being tuned becomes too weak to receive, press the same preset location button to tune in a Regional station in other district. Press and hold the INT button for at least 3 seconds to activate the setting mode. Press the F3 button to turn on or off the REG (Regional) mode. When traffic information stations cannot be received: In the tuner mode: When the TP signal can no longer be received, an alarm will be sounded after 1 minute. In the tape mode: When the TP signal can no longer be received, the traffic information station of another frequency will be selected automatically. Note: The receiver is equipped with the EON (Enhanced Other Networks) function in order to keep track of additional alternate frequencies to the AF list. If the station being received does not broadcast the traffic information, the receiver automatically tunes in the related station that broadcasts the traffic information when it occurs. This function allows presetting of a programme type such as music category, news, etc. You can listen to a programme in the preset programme type as the unit automatically gives priority to the preset programme type when it begins broadcasting, and interrupts the programme you are currently listening. This feature is functional when your unit is set to a mode other than the LW and MW modes. "PRIO PTY" is displayed for 2 seconds and then the program type for 5 seconds. [. . . ] ** The button is effective with Ai-NET system unit used. Opening the battery case 1 Place the remote upside down on a flat, level surface. Looking at the back of the remote, grasp the battery holder at the bottom of the unit between your forefinger and thumb. Insert a pointed object into the left side of the elongated hole. [. . . ]