User manual ALPINE TDA-7572R

[. . . ] Operating the equipment may distract the driver from looking ahead of the vehicle and cause accident. Always stop the vehicle in a safe location before operating this equipment. Keep the volume at a level where you can still hear outside noises while driving. Driving while unable to hear outside noises could be the cause of accident. [. . . ] Note: If you store a station in a preset memory which already has a station, the current station will be cleared and replaced with the new station. Each press changes the band: F1 F2 F3 LW MW The frequency on the display continues to change while the automatic memory is in progress. The tuner will automatically seek and store 6 strong stations in the selected band in order of signal strength. When the automatic memory has been completed, the tuner goes to the station stored in the preset location No. Note: If no stations are stored, the tuner will return to the original station you were listening to before the auto memory procedure began. Each press changes the band: F1 F2 F3 LW MW Make sure that the Function indicator is not illuminating, and press the station preset button that has your desired radio station in memory. The display shows the band, preset number with a triangle and frequency of the station selected. The RDS allows you to receive a variety of information such as traffic information, station names, and to automatically re-tune to a stronger transmitter that is broadcasting the same programme. Note: Use the AF OFF mode when automatic re-tuning is not required. Choose your desired station in 5 seconds after the above step 2. Note: When the BAND button is pressed and held for more than 2 seconds while a station name is displayed, the display shows the station frequency for 5 seconds. When a traffic information broadcast starts, the unit automatically adjusts the volume to the preset level. The Programme Type of the station being currently received will be displayed for 5 seconds. If no RDS station can be received, the display shows "NO RDS. " Note: If no button is pressed within 5 seconds after pressing the F2 button, the PTY mode will be automatically cancelled. Press the g DN and UP f buttons within 5 seconds after activating the PTY mode to choose the desired programme type while the PTY (programme type) is being displayed. Press the F2 button within 5 seconds after selecting the programme type to start searching for a station in the selected programme type. When the cassette is loaded, the player automatically starts tape playback and indicates "TAPE" in the display. When power is turned off or the front panel is removed, the full-logic mechanism will automatically switch to the PAUSE mode. This protects the tape from being deformed by the pinch-rollers if left for long periods. Auto Metal When a metal cassette tape is inserted, the player automatically adjusts to the equalization for metal or any other high bias tape for optimum sound. To close the front door, gently push the front door until it locks. [. . . ] Equalizer/Surround mode: After calling each mode with the A. pROC button , press the 8 button to select each mode. 8 g Button Radio mode: SEEK (DN) Button Tape mode: REW Button 3D/CD Shuttle mode: Press the button to go back to the beginning of the current track. 9 f Button Radio mode: SEEK (UP) Button Tape mode: FF Button 3D/CD Shuttle mode: Press the button to advance to the beginning of the next track. [. . . ]