User manual ALPINE TME-M750 MANUAL 2

[. . . ] Doing so may obstruct forward vision or hamper movement. dO NOT CONTACT , DAMAGE OR OBSTRUCT PIPES , FLUID LINES OR WIRING WHEN DRILLING HOLES. Failure to take such precautions may result in fire or cause an accident or injuries. dO NOT USE NUTS OR BOLTS IN THE BRAKE SYSTEM WHEN MAKING INSTALLATION OR GROUND CONNECTIONS. [. . . ] Moisture or dust that penetrates into this unit may cause smoke or fire. In the PAL mode, characters may freeze or banding may occur in some images. Make sure you have selected the correct video mode for your system. If properly connected, the monitors main POWER will turn off when the vehicle's ignition switch is off. If the main power lamp illuminates in the STAND BY mode, the vehicle's battery may be discharged. Each press of the button will cycle through the modes as follows: Each press of the button will cycle through the modes as follows: BRIGHT COLOR TINT DIMMER DIMMER LEVEL DIMMER: AUTO: Backlighting of the monitor adjusts automatically to the ambient light available inside the vehicle. DISPLAY MODE: WIDE: Expands a normal broadcast picture to fit the entire screen. CINEMA: Displays a widescreen formatted picture (16:9) to fit the entire screen. ZOOM: Displays a normal broadcast picture to fit the entire screen by cropping the left and right video information. After completing adjustments, press and hold the SELECT button for at least 1 sec. notes: · After turning the system off, a slight ghost of the image will remain temporarily. Under cold temperature conditions, the screen may lose contrast temporarily. After a short warm-up period, it will return to normal. It is normal for a very small number of the screen's pixels to be off. Even under the very high precision manufacturing conditions, this fact is unavoidable. If you encounter a problem, please review the item in the following check list. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer. * Brightness/Colour/Tint control are not set to the proper positions. Caused by neon signs, high-voltage power lines, CB transmitter, other vehicle's ignition plugs, etc. Wait until the temperature inside the vehicle comes down to the operating temperature range (45°C). The fluorescent tube replacement is not free of charge even within the warranty period, for the tube is an article of consumption. [. . . ] Remove the protective strip from the other side of the VelcroTM pad. Press the unit onto its mounting location. Numbers Identification 1 Floor/Trunk 2 VelcroTM Tape (Included) 3 Press onto the carpet. 1 1 23 4 5 6 7 8 9 Ä Å Parking brake lead (Yellow/Blue) Connect this lead to the parking brake lead powered when parking brake is pulled. [. . . ]