User manual ALPINE TMX-R700

[. . . ] (Check with your dealer if you are not sure. ) Failure to do so may result in fire, etc. BEFORE WIRING, DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL Before doing any electrical wiring, disconnect the cable from the negative () terminal of the battery. Failure to do so may result in electric shock or injury due to electrical shorts. KEEP ELECTRICAL CABLES TOGETHER TO AVOID OPERATING HAZARDS Dress the wiring to keep them from interfering with the operation of the steering wheel, gear lever, brake pedals, etc. [. . . ] At the same time, the LCD will maintain its horizontal view while being rotated from left to right, up to 30 degrees, in 10 degree steps. NOTE: The LCD will only close when rotation is at 0 degrees to prevent damage to the monitor. When rotating the monitor, use both hands on either side of the panel to ensure even pressure on the mechanism. This will prevent damage to the SmartViewTM Swivel mechanism. Make sure the panel is fully opened (90 degree position) before trying to rotate. 3) LCD Monitor Panel This is a 7 inch, Widescreen TFT, Active Matrix LCD. In addition, an Infrared Wireless Headphone transmitter is located on top of the LCD panel. When the monitor panel is closed, the power is automatically turned off. NOTE: Whenever the LCD Panel is opened from closed position or Ignition/ACC is ON at opened position, the Main Power is turned on automatically. 4) Monitor Open Button Press this button to release the Monitor Panel. The Panel will drop down slightly allowing you to fully open to its 90 degree or greater position. To close, firmly press the LCD Monitor Panel back up into the housing until a click is heard. 5) Built-in Dome Light To replace the bulb, gently open the dome light lens from the front . SYLVANIA DE3022) 6) Alpine Back-lit Logo Blue, back-lit ALPINE logo will turn on when the overhead monitor main power is on. OPERATION - Remote Control REMOTE CONTROL Power Press this button to turn Main Power to the TMX-R700 ON or OFF (Ignition/ACC must be ON and the LCD Panel must be open). Closing the LCD Panel turns Main Power OFF automatically. NOTE: Whenever the LCD Panel is opened from the closed position or Ignition/ACC is ON at opened position, the Main Power is turned on automatically. Disp Press this button to cycle through the display modes as follows: WIDE CINEMA ZOOM NORMAL WIDE: Normal images are expanded uniformly in the horizontal direction and are displayed over the entire screen. CINEMA: Normal images are expanded in the horizontal and vertical directions. The top and bottom of the image is cut off. This mode is suited for 16:9 cinema size images. ZOOM: Normal images are expanded in the horizontal direction and are displayed over the entire screen. The expansion ratio increases towards the right and left edges of the screen. NORMAL: Normal image (4:3) Source Press the Source button to toggle between the three A/V sources (AUX1, AUX2 and AUX3). [. . . ] Tel. : 1-800-ALPINE1 (1-800-257-4631) 1-888-NAV-HELP (1-888-628-4357) ALPINE ELECTRONICS OF CANADA, INC. Markham, Ontario L3R 9Z6, Canada Tel. : 1-800-ALPINE1 (1-800-257-4631) ALPINE ELECTRONICS OF AUSTRALIA PTY. 6-8 Fiveways Boulevarde Keysborough Victoria 3173, Australia Tel. : (03) 9769-0000 ALPINE ELECTRONICS GmbH Kreuzerkamp 7-11 40878 Ratingen, Germany Tel. : 02102-45 50 ALPINE ITALIA S. p. A. Viale C. Colombo 8, 20090 Trezzano Sul Naviglio (MI), Italy Tel. : 02-48 47 81 ALPINE ELECTRONICS FRANCE S. A. R. L. [. . . ]