User manual ALPINE TMX-R705

[. . . ] R EN TMX-R705 Mobile Overhead Monitor · OWNER'S MANUAL Please read before using this equipment. · BEDIENUNGSANLEITUNG Lesen Sie diese Bedienungsanleitung bitte vor Gebrauch des Gerätes. · MODE D'EMPLOI Veuillez lire avant d'utiliser cet appareil. · MANUAL DE OPERACIÓN Léalo antes de utilizar este equipo. [. . . ] Press the 9 or 8 button within 10 seconds and select DIMMER Lv. or button within 10 seconds to set SET UP AUX1 DIMMER AUTO DIMMER Lv. AT CLOSE OFF LOW HIGH PAGE 2 4 AUTO: Automatic closing of the display in depending upon whether the ignition switch is ON or OFF. If you press the POWER button or the OPEN/ CLOSE button while the monitor is being opened or closed, the monitor stops opening or closing, even if AUTO setting is on, and cannot be closed automatically. In this case, press the POWER button or the OPEN/ CLOSE button again to close the monitor. OFF: Manual closing of the display. SET UP AUX1 DIMMER AUTO DIMMER Lv. AT CLOSE OFF PAGE 2 9 9 9 Press the SETUP button to finish adjustments. 9 FR ES DE AUTO OFF 4 Press the SETUP button to finish adjustments. IT SE 9-EN Other Useful Features Dome Light Settings 1 Press the DOME LIGHT button to turn the Dome Light ON or OFF regardless of whether the vehicle's doors are open or closed. Door Closed: The dome light will remain lit until the vehicle's door is opened and closed. The dome light will return to Auto mode. To switch OFF the dome light manually, press the DOME LIGHT button again. Door Open: The dome light will remain OFF until the vehicle's door is closed and re-opened. The dome light will return to Auto mode. To switch ON the dome light manually, press the DOME LIGHT button again. NTSC/PAL Switching Function You can switch the NTSC/PAL setting in the AUX1 or AUX2 mode. 1 2 3 Press the SETUP button. Press the 9 or 8 button within 10 seconds and select AUX 1 SIG. Press the or the selection. button within 10 seconds to set · With the dome light ON and the vehicle's door OPEN, press and hold the DOME LIGHT button for at least 3 seconds. The dome light will be switched OFF permanently regardless of the opening and closing of the vehicle's doors. To cancel, with the vehicle's door open, press and hold the DOME LIGHT button for at least 3 seconds. NOTE If the Override button is connected, it will always work regardless of the Remote Dome Light Status. AUX 1 SIG. AUX 2 SIG. NTSC PAL 9 SET UP AUX1 NTSC PAL PAGE3 1 3 4 Press the SETUP button to finish adjustments. NOTE The TINT adjustment is not possible when the PAL is setted. TIPS NTSC and PAL can be directly switched when the DISP button is pressed for at least 2 seconds. 10-EN 9 Battery Replacement Applicable battery: Use two "AAA" sized dry batteries or equivalent. · Point the remote control transmitter toward the remote sensor on the TMX-R705 and use the remote control within 2 meters from the TMXR705. Replacing the Dome Light Bulb NOTE When replacing the dome light bulb, replace with one of the specified 12V, 5W capacity. Use of a different capacity bulb may cause damage to the unit. Please note that no guarantee is carried out if this is the case. 1 2 3 4 5 1 Opening the battery cover. [. . . ] Doing so may cause damage. SE 15-EN Installation and Connections Connections To other monitor AUX-IN 2 connector AUX-IN 1 connector 5m Mini-DIN Extension Cable 5m Mini-DIN Extension Cable Audio/Video output connector Common Ground (Black) Left Positive (Blue) Right Positive (Green) Connect to the cable of the vehicle side (Rear View) Dome Light-Always OFF (Gray/Green) 1 GND (Black) w 5 2 3 4 6 7 1 2 3 p 9 Dome Light-Always ON (Red/Green) Dome Light-Door (Blue/Green) Mini-DIN to RCA Interface Mini-DIN to RCA Interface Accessory/Ignition (Red) GND (Black) Ext. A/V Select (Pink/Blue) IR Remote Out (White/Brown) Remote Turn-on (Blue/White) q w e r Dome Light Battery (Yellow/Green) Battery (Yellow) Dome Light Rocker switch is located on Alpine overhead console 8 Accessory/Ignition (Red) GND (Black) Ext. A/V Select (Pink/Blue) To AUX Output q w e r t To AUX Input (AUX 2) For Front Monitor Tune Box For Front Monitor (Sold Separately) (CVA-1006R etc. ) IR Remote Out (White/Brown) t To AUX Input (AUX 1) To Audio/Video Output Terminals i Ai-NET Connector Remote Out Aux 1 (White/Brown) Video Game Console (Sold Separately) To Audio/Video Output Terminals To Audio/Video Output o i u y Remote IN (White/Brown) Video Player (Sold Separately) Ai-NET Connector DVD Changer (Sold Separately) 16-EN 1 Dome Override (Always OFF) (Gray/Green) Connecting to Pin #1 of the external dome light SW. When it is grounded, the Dome light remains off all the time. 7 BATT (Main Unit) (Yellow) This is a constant + 12V for the main unit. [. . . ]