User manual ALPINE TUE-T112P

[. . . ] EN TUE-T112P MOBILE TV TUNER SYSTEM · OWNER'S MANUAL Please read before using this equipment. · BEDIENUNGSANLEITUNG Lesen Sie diese Bedienungsanleitung bitte vor Gebrauch des Gerätes. · MODE D'EMPLOI Veuillez lire avant d'utiliser cet appareil. · MANUAL DE OPERACIÓN Léalo antes de utilizar este equipo. [. . . ] Press the A. MEMO button on the remote controller. The auto memory function starts and TV broadcast signals are picked up and stored in memory while scanning. 8-EN Setting the channel selection You can set the channel selection method either to select only the receivable channels in memory or to select all the channels. Remember that if you want to select only the receivable channels, you must store the channels first. To store them, see page 8. AUTO: Only the receivable channels stored in memory can be selected. When you change the channel, channel number and "AUTO" appear on the screen for a while. MANUAL: All the channels can be selected. (Channel coverage: VHF channels 1 to 12, UHF channels 21 to 69) Remote controller 1 2 Select TV as the input source. Press the TV/AV button on the remote controller repeatedly to select TV. Set the channel selection to "AUTO" or "MANUAL. " Press the SEEK button on the remote controller. Each time you press the button, the channel selection alternates between "AUTO" and "MANUAL. " 9-EN Watching playback of external component You can connect up to 2 external video components to the TV tuner unit. To watch the playback, first follow steps 1 and 2 on page 7, then perform the following steps. AUX1 Ex: When AUX1 is selected 2 3 Play back the external component. To operate the external components, refer to the manuals of the connected components. Adjust the volume level on the car receiver. To check the current input source Press the CH CALL button on the remote controller. The current input source name appears on the screen for 3 seconds. Remote controller To turn off the power Press the POWER button on the remote controller. · Turning off the engine will also turn off the TV tuner system. NOTES · When you watch the screen aslant, the picture might not be clear. The finest picture can be seen when you watch the screen straight. 1 Select the input source. Press the TV/AV button on the remote controller to select the input source you want. Each time you press the button, the input source changes as follows: TV AUX1 AUX2 The selected input source name also appears on the screen for 3 seconds. 10-EN Adjusting the headphone volume Press and hold the VOL UP or VOL DN button to adjust the headphone volume. You can adjust the volume level between 0 and 35. VOL DN and VOL UP The headphone volume level appears on the screen. NOTE This adjustment is only for the connected headphones but not for the speakers in the car. When adjusting the speaker volume, adjust it by using the car receiver. 11-EN Maintenance To prevent damage to the system exterior · Do not apply pesticides, benzine, thinner or other volatile substances to the unit. The cabinet surface primarily consists of plastic materials. [. . . ] Do not tap into these leads to provide power for this unit. When connecting the TUE-T112P to the fuse box, make sure the fuse for the intended circuit of the TUE-T112P has the appropriate amperage. Failure to do so may result in damage to the unit and/or the vehicle. When in doubt, consult your ALPINE dealer. [. . . ]