User manual ALTEC LANSING 1224A SPEAKER SYSTEM

[. . . ] Com to register your product online, so we can provide you with the best possible service and technical support. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. [. . . ] Press the button on the speaker system or the button on the clip-on remote to turn the speaker system back on. NoTe The speaker system is compatible with the alarm clock and sleep timer features built into select iPhone and iPod models. For these features to work properly, the speaker system must be connected to a wall outlet. When an iPhone or iPod is docked, the speaker system will not shut down automatically, enabling the alarm or sleep timer to play through the speaker system. See the user guide for iPhone or iPod for details on how to access these features. NoTe During AC operation, if there is no iPhone or iPod docked and no audio input signal is detected for a few minutes, the speaker system automatically shuts down to conserve energy. Press the button on the speaker system or the button on the clip-on remote to turn the speaker system back on. Press the "SOURCE" button on your speaker system or clip-on remote until the iPod icon appears on the LCD. Music from your iPhone or iPod will start playing. The speaker system and the clip-on remote are capable of controlling basic functions of 3rd-generation iPod models, the iPod touch, the iPod nano and the iPhone. Press the or button on your speaker system or clip-on remote to go to the next or previous track. Whenever your iPhone or iPod is docked and your Altec Lansing inMotion Max speaker system is plugged into an AC outlet, your iPhone or iPod is charging (until fully charged) ­ even if the speaker system is switched off. CAUTioN: The iPhone or iPod will not charge when the speaker system is operating on batteries. How to Store Preset Stations Your Altec Lansing Mix speaker system's clip-on remote enables you to program up to 4 FM station presets: While in "FM" mode, use the or buttons on your speaker system or clip-on remote to tune to the desired station. You can store one FM station in each preset. To store other stations, repeat the above steps. Press the "SOURCE" button on your speaker system or clip-on remote until "FM" appears on the LCD. How to recall Preset Stations Make sure you are in "FM" mode. If you're not in "FM" mode, press the "SOURCE" button on your speaker system or clip-on remote until "FM" appears on the LCD. Use the or buttons on your speaker system or enhanced remote to tune in the desired station. Press and hold these same buttons to find the next clear FM station. Use the knob on your speaker system to adjust the system volume. [. . . ] If the problem appears to be related to a defect in material or workmanship, Altec Lansing will provide you a return authorization and instructions for return shipment. Return shipments shall be at the customer's expense, and the return must be accompanied by the original proof of purchase. You should insure the shipment as appropriate because you are responsible for the product until it arrives at Altec Lansing. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. [. . . ]