User manual ALTEC LANSING 9444A POWER AMPLIFIER

[. . . ] Indd 1 2012-03-02 9:28:47 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. GENERAL ERROR FUNCTION NO 1 Error Code nd Diagnostic Code Error Image nd Description The water level fails to drop below the Reset Water Level within 15 minutes. 2 LO LO 3 nF nF When the filling Continues for Go to “ No Water Fill” more than 40 minutes or there is no Troubleshooting Section. 4 FL FL 5 LE LE A water level lower than the Reset water level (25. [. . . ] Indd 9 2012-03-02 9:28:49 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. Fast Time Down Test Mode Definition of Fast Time Down Test Mode: - Fast Time Down Test Mode is to forward the program to the next cycle stage. How to Enter: - To enter the Fast Time Down Test Mode, press the Temp key during Service Mode. To forward the program to the next cycle stage, press the Temp key. Each stage is located at key points of a complete cycle as follows: - End of Each Fill (Beginning of Wash or Rinse Tumble Session) Caution: Check if the current water level is higher than the Reset water level and then perform the Fast time down test. - Beginning of Drain Session - Beginning of Spin Session (Here , it checks the water level. So, if it is over the reset level, it carries out draining before the spinning. ) - Beginning of Fill Session - Beginning of Bleach Fill - Beginning of Fabric Softener Fill - Every 3 minutes during Wash and Rinse Tumble Session 10 WF405ATP-03144A_EN. Indd 10 2012-03-02 9:28:49 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. Board Input Test Mode Definition of Board Input Test Mode: - Board Input Test Mode is to displays a specified input after a key press. How to Enter: - To enter the Board Input Test Mode, press the Extra Rinse Key during Service Mode. After the five (5) minutes have elapsed, “- - - -” is displayed on the 7 segment display and the initial Demo mode is maintained. - If the Start/Pause button is pressed during a WASH mode operation, “- - - -” is displayed on the 7 segment display and the initial Demo mode is maintained. - If the Spin button is pressed in the initial Demo mode, “Spin” blinks on the 7 segment display and the washing machine enters SPIN mode. - If the Start/Pause button is pressed in the SPIN mode, the door is locked (Door Lock) and a spin is operated at 1200 RPM. B, the electric shock may occur by touching and be careful that the strong and weak electricity are mixed. B assembly is designed for no trouble, do not replace the P. B assembly by the wrong diagnosis and follow the procedure of the trouble diagnosis when the micom is not operated normally. Indd 14 2012-03-02 9:28:50 TROUBLE SHOOTING WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. TROUBLE DIAGNOSIS Will Not Start • Plug the unit into the wall outlet. € Push any key to turn on the washer and press the Start/Pause key to run the washer. € Close door and push the Start/Pause key to run the washer. [. . . ] also check water heater capacity and recovery rate. € If the water heater is located far from the washer, screw out the hot water tap and let its water pass until you get hot water. € Too Hot/Too Cold: Reduced amount of water is supplied while PCB controls the influx to regulate the actual temperature of the water in the tub. This may appear to be significantly hotter/colder than expected. [. . . ]