User manual ALTEC LANSING A7-8G VOTT SPEAKER SYSTEM

[. . . ] Steam cycle This cycle sprays a small amount of water into the dryer drum after several minutes of tumbling with heat. It reduces bad odors from clothing that are difficult to remove when washing with water, and also reduces wrinkles. Sanitize course This course allows you to sanitize garments by permeating high temperature heat deep into the fabric during the drying cycle. Use this course to keep your bedding and curtains clean. [. . . ] Indd Sec2:15 2011-03-28 ¿ÀÈÄ 3:42:01 installing your dryer REPLACEMENT PARTS AND ACCESSORIES If your dryer requires replacement parts or accessories, contact the dealer from whom you purchased your dryer or the ALTEC LANSING customer care center at 1-800-ALTEC LANSING(726-7864). INSTALLATION Gather the required tools and parts before starting the installation. Read and follow the instructions provided with any tools listed here. Tools and Parts Pliers Cutting knife Pipe wrench (gas only) Nut drivers Level Phillips Screwdriver Duct tape Wrench For proper installation, we recommend that you hire a professional. Move your dryer to an appropriate location for installation. Consider installing the dryer and washer sideby-side, to allow access to gas, electrical, and exhaust connections. Lay two of the carton cushion-tops on the floor. Tip your dryer on its side so it will lay across both cushion-tops. Set your dryer back in an upright position. To ensure that the dryer provides optimal drying performance, it must Level be level. To minimize vibration, noise, and unwanted movement, the floor must be a perfectly level, solid surface. Check all gas connections for leaks using a soap solution. if bubbles appear , tighten the connections and recheck. DO NOT use an open flame to check for gas leaks. Loosen or remove the center terminal block screw. Connect the neutral wire (white or center wire) of the power cord to the center, silver-colored terminal screw of the terminal block. Connect the other wires to outer terminal block screws. Insert the tab of the terminal block cover into your dryer’s rear panel slot. Secure the cover with a hold-down screw. Center silver-colored terminal block screw 4. 9 cm) UL-listed strain relief If converting from a 4-wire electrical system to a 3-wire, the ground strap must be reconnected to the terminal block support to ground the dryer frame to the neutral conductor. Connect the ground wire (green or unwrapped) of the power cord to the external ground conductor screw. [. . . ] Follow care label directions to maximize garment life and reduce laundering problems. Wash Cycle Normal Permanent Press / Wrinkle Resistant / Wrinkle Control Gentle/Delicates Hand Wash Water Temperature** Hot Warm Cold Bleach Any Bleach (when needed) Only Non-Chlorine (color-safe) Bleach (when needed) Tumble Dry Cycle Normal Permanent Press/ Wrinkle Resistant/ Wrinkle Control Gentle/ Delicates ** The dot symbols represent appropriate wash water temperatures for various items. The temperature range for Hot is 105° –125° F/ 41° – 52° C, for Warm 85° – 105° F/29° – 41° C and for Cold 60° – 85° F/16° – 29° C. (Wash water temperature must be a minimum of 60° F/16° C for detergent activation and effective cleaning. [. . . ]