User manual ALTEC LANSING A7-MR994A VOTT SPEAKER SYSTEM

[. . . ] Steam Cycle This cycle sprays a small amount of water into the dryer drum after several minutes of tumbling with heat. It reduces bad odors from clothing that are difficult to remove when washing with water, and also reduces wrinkles. Sanitize Cycle This cycle sanitizes garments by infusing high temperature heat deep into the fabric during the drying cycle and eliminating 99. Use this cycle for clothing, bedding, towels, or other items needing sanitization. [. . . ] A 4-WIRE SYSTEM CONNECTION is required for new or remodeled construction, mobile homes, or if local codes do not permit grounding through neutral. If you use the 4-wire system, you cannot ground the dryer frame to the neutral conductor at the terminal block. Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the terminal block. 01 installing your dryer A strain relief must be used. Do not loosen the nuts already installed on the terminal block. Use a 3/8” (1 cm) deep well socket. For instructions, go to Connecting the Inlet Hose on page 10. To ensure that the dryer provides optimal drying performance, it must be level. To level the dryer, follow the lettered steps below: a. Using a level, check if the dryer is level side to side and then front to back. If the dryer is not level, adjust the leveling feet on the bottom of the dryer until the washer is level side to side and back to front. If space permits, attach the brass female end of the “Y”connector to the cold water faucet. Attach the straight end of the long hose to the “Y’ connector. Screw on the hose coupling by hand until it is tight. Using pliers, tighten the hose coupling with an additional two thirds turn. Attach the angled end of the long hose to the fill valve at the bottom of the dryer’s rear frame. Screw on the coupling by hand until it is tight. Using pliers, tighten the hose coupling with an additional two thirds turn. Attach the water hose to the other side of the “Y” connector. Screw on the hose coupling until it is tight. Using pliers, tighten the coupling with an additional two thirds turn. Check for leaks around “Y” connector, faucets, and hoses. [. . . ] , (ALTEC LANSING) and delivered new, in the original carton to the original consumer purchaser, is warranted by ALTEC LANSING against manufacturing defects in materials and workmanship for a limited warranty period of: 06 appendix One (1) Year All Parts and Labor This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the CANADA. To receive warranty service, the purchaser must contact ALTEC LANSING for problem determination and service procedures. warranty service can only be performed by a ALTEC LANSING authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to ALTEC LANSING or ALTEC LANSING’s authorized service center. [. . . ]