User manual ALTEC LANSING INMOTION CLASSIC

[. . . ] Caution: To prevent the risk of electric shock, do not remove cover (orback). CAUTION Topreventelectricshockdonotusethis(polarized)plugwithanextensioncord, receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure. WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Do not install near any heat sources such as radiators, heat registers, stoves, or otherapparatus(includingamplifiers)thatproduceheat. [. . . ] Selectapresetradiostation Change audio source Enter the menu on the iPod Navigate up in the menu Navigate down in the menu Navigate back in the menu Make a selection in the menu ActivateExpandedSoundStage proprietary technology Mute the audio NOTE During battery-only operation, the speaker system automatically shuts down if no audio is detected for a few minutes. Press the button to turn the speaker system back on. NOTE The speaker system is compatible with the alarm clock and sleep timerfeaturesbuiltintoselectiPhoneandiPodmodels. Forthesefeatures to work properly, the speaker system must be connected to a wall outlet. WhenaniPhoneoriPodisdocked, thespeakersystemwillnotshutdown automatically, enabling the alarm or sleep timer to play through the speaker system. seetheuserguideforiPhoneoriPodfordetailsonhowtoaccess these features. NOTE During AC operation, if there is no iPhone or iPod docked and no audio input signal is detected for a few minutes, the speaker system automatically shuts down to conserve energy. Press the button to turn the speaker system back on. Music from your iPhone or iPod will start playing. Press the or button on your speaker system or full-featured remote to go to the next or previous track. Press and hold the or button on your speaker system or full-featured remote while track is playing for high-speed forward or reverse music search of the current track. How to Access Additional Features on Your iPhone or iPod Using the Full-featured Remote PresstheP1buttononceonthefullfeatured remote to advance to the next shufflemode. RPTOFFisdisplayed when the repeat function has been turned off. WheneveryouriPhoneoriPodisdockedandyourAltecLansinginMotion Classic speaker system is plugged into an AC outlet, your iPhone or iPod is charging(untilfullycharged)­evenifthespeakersystemisswitchedoff. How to Store Preset Stations Your Altec Lansing speaker system's full-featured remote enables you to programupto4FMstationpresets: To store other stations, repeat the above steps. Use the or buttons on your speaker system or full-featured remote to tune in the desired station. How to Recall Preset Stations Make sure you are in "FM" mode. When you are finished listening to your portable audio device, please remember to turn both it and your speaker system off to conserve electricity. Your device should have either a headphoneorLINEOUTjackforyou to plug into. Place your speaker system on a level surface away from sources of direct sunlight or excessive heat. Protect your furniture with a cloth or other protective material when placing your speaker system on a natural wood or lacquered finish. Clean your speaker system with a soft cloth moistened only with mild soap andwater. [. . . ] You should insure the shipment as appropriate because you are responsible for the product until it arrives at Altec Lansing. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Oire Mahdollinen ongelma Volume level is set too high. IftheiPhoneoriPodoriginalsoundsource(MP3)isofpoorquality, distortion and noise are easily noticed with high-power speakers. [. . . ]