User manual ALTEC LANSING OCTIV AIR

[. . . ] Altec Lansing octivTM AIR Wireless Speaker System for iPod® M812 User Guide The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Caution: To prevent the risk of electric shock, do not remove cover (or back). Refer servicing to qualified service personnel. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Safety Information CAUTION To prevent electric shock do not use this (polarized) plug with an extension cord, receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Do not use this apparatus near water ­ This apparatus shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the apparatus. Install in accordance with the manufacturer's instructions. [. . . ] The factory default is STEREO. 2 Display 1 1 1 2 2 DISPLAY Displays selected source, FM frequency and menu information. The display will automatically dim six seconds after the last key has been pressed on the speaker unit or remote control. IR SENSOR IR receiving sensor for use with supplied IR remote control. 2 5 Transmitter Base Front Panel 1 STANDBY / ON Switches the power mode between Standby and On for the transmitter base. This light (left of the STANDBY key) illuminates when the transmitter base is on. SYNC 1 LED Illuminates to indicate that the transmitter base is synchronized with one wireless speaker unit. SYNC 2 LED Illuminates when two or more M812 wireless speaker units are connected and synchronized with the transmitter base. Any speaker that is synchronized can control the system. 2 1 2 3 3 Rear Panel 1 2 3 1 AUX Connect auxiliary devices (e. g. , portable CD players) to 3. 5 mm stereo, line-level input jack using supplied cable. FM Connect the supplied 75 Ohm FM "T" antenna. 9VDC Connect the supplied 9V DC/1. 6A wall adapter. Connect only the adapter supplied with the M812. 2 3 6 Remote Control 1 2 1 STANDBY/ON key Turns on the M812 or places it in standby mode. MASTER VOL +/­ keys Press to adjust the volume of several speakers when they are all synchronized with the transmitter base. If you have only one speaker, these keys operate the same as +/­ keys on the ring of controls on the lower part of the remote and the volume controls on the side of the speaker. BASS +/­ keys Adjusts the bass tones of the speaker up or down from -6 to +6 decibels. TREBLE +/­ keys Adjusts the treble tones of the speaker up or down from -6 to +6 decibels. iPOD/FM/AUX keys Press to select an input source. 1-6 keys Used to select and set FM station presets. To preset an FM station: Tune to the desired FM Station. Press and hold one of the preset keys for three seconds. The display will show PRESET and the number of the preset key. +/­ keys Control the volume of a single speaker. (FR/FF) keys For iPod: ·Pressoncetomovetothepreviousornexttrack. ·Pressandholdthekeytodoafastforwardorrewind. [. . . ] To manually regain synchronization between the transmitter base and the speakers, hold down the STANDBY key on the transmitter base for six seconds. The speakers will then synchronize with the transmitter base. You can manually re-synchronize the speaker by holding down the POWER key on the speaker for six seconds. The speaker will then synchronize with the transmitter base. [. . . ]