User manual ALTEC LANSING VS2621

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. [. . . ] Press " " or " " button to tune into a desired station. Press " " button until "CH 01" appears on the display, then press " " or " " button select a desired channel. " button to save and "SAVE" 3. Press " indicator appears on the display. Repeat steps 1 to 3 to preset other stations. VOL VOL Tuning into a Preset Channel 1. Press " M " button until "PRESET" appears on the display. Press " " or " " button to select a preset channel and the channel number appears on the display, then it will operate automatically. Press " M " button once and the "MANUAL" appears on the display, then press " " button to exit the preset channel. VOL VOL VOL Auto Search and Store FM Stations 1. Press and hold "M" button until the tuner starts searching for a station. After tuning into a station, the station will be stored to the preset channel "CH 01" automatically. Then it will automatically continue to search and store other stations (up to 20 channels "CH 20"). -9- TO Delete the Preset Channel 1. · INTRO play always starts from the track that immediately follows the current running one. · Press " " or " " to start intro play from the selected track. -13- INTRO VOL RANDOM - Playing tracks in random order (In AUTO PLAY OFF mode only) 1. Press " + " or " - " button in RPT_MODE until "Random"appears on the display. Press " " button once to confirm. Press " " button again to start play. · All tracks of the current folder will be played without sequence, after all tracks of the current folder are played, the system will stop automatically. · To locate the next track: press " " button. However, you can not locate a previous track even if you keep " " button pressed. RPT ALL (Repeat all) 1. Press " + " or " - " button in RPT_MODE until "RPT ALL"appears on the display. Press " " button once to confirm. Press " " button again to start play. [. . . ] Please use the installation CD-ROM to install the driver and follow the processes below. If the player is recognized on your PC, the "Add New Hardware Wizard" is activated, and click "Next". -18- 3. Select "Search for the best driver for your device (Recommended)". Select "CD-ROM Drive" and click "Next". -19- 5. [. . . ]